QUESTION: 57 While attempting to log into a Communication Server 1000 Rls. 5.0 system using Element Manager, you receive the following message:WEB3003: Destination IP address cannot be reached, initial RPC fail. Which signaling server command will verify that both the ELAN link is established and the Call Server IP address is correct? 22
A. Use stat elnk from Overlay (LD) 137. B. Use pbxLinkShow from "oam>" shell of the Signaling Server. C. Use the stat elnk command from "oam>" shell of the Signaling Server. D. Use the itgCardShow command from the "oam>" shell of the Signaling Server. Answer: B QUESTION: 58 A customer site with a Communication Server 1000E system has multiple elements in a node. The customer has reported that an 1140E IP telephone in the node is constantly rebooting and downloading firmware. To isolate the problem, the technician will verify that each element in the node has the same F/W version installed, since only one F/W version can be installed on a given node. Which command displays the firmware version that will be downloaded to the IP telephone? B QUESTION: 59 A Communication Server 1000 Rls. 5.0 customer has received reports from outside callers that occasionally there are loud bursts of static interfering with conversations. Upon further investigation and monitoring, you have determined that this noise is present on all PRI trunk cards in the system. The Media Gateway Controller (MGC) log file did not provide any additional information to help you resolve the problem. Which step should you take next to determine the root cause of the problem? 23
D QUESTION: 60 After using the DSPselfTest command to initiate a Media Card self test, you observe that the self test has failed. How do you resolve this issue? A 24
For More exams visit http s ://killexams.com /vendors-exam-list Kill your exam at First Attempt .... Guaranteed!
You've reached the end of your free preview.
Want to read all 7 pages?
- Summer '20
- IP address