Course Hero Logo

Engine overhauling stand that appears damaged in any

Course Hero uses AI to attempt to automatically extract content from documents to surface to you and others so you can study better, e.g., in search results, to enrich docs, and more. This preview shows page 18 - 20 out of 83 pages.

Engine overhauling stand that appears damaged in any way, operates abnormally or ismissing parts shall be removed from service immediately. If you suspect that the engineoverhaulingstand was subjected to a shock load (a load dropped suddenly, unexpectedly uponit), immediately discontinue use until it has been checked by a factory authorized service center(contact distributor or manufacturer for list of authorized service centers). It is recommended thatan annual inspection be done by qualified personnel.Before each use check; Engine overhauling Stand clean and free of dirt or grease, hardware issecurely fastened, Casters are clean and turn properly.OperationAlways verify that the product and theapplication are compatible. Neverload theengineoverhauling stand with an engine that extends beyond animaginary1. Ensure application is compatible with product.2. Align engine with stand, then adjust mounting arms to match bell housing mountingholes. Rotational lock must be secure before applying load.3. Carefully secure engine so that load is centered on stand. Secure with high strength studbolts and flat washers. Ensure threads are compatible with your engine, and use washers on bothsides of head plate.4. To rotate engine, slowly and carefully release locking mechanism. Use original handle torotate, then secure by engaging locking mechanism.5. Check to ensure stand is secure before working on or around stand.After useClean external surfaces of the stand with a clean, moist cloth.Assembly precautionsKeep assembly area clean and well lit.Keep bystanders out of the area during assembly.Do not assemble when tired or when under the influence of drugs or medication.Weight capacity and other product capabilities apply to properly and completely assembledproduct only.2.2.5 Operating Instructions
Wollo university (KIOT) department of mechanical engineeringPage 11Mounting EngineTo prevent serious injury: Before attaching an engine to the stand, confirm that its weight doesnot exceed the Stand maximum capacity.1.Remove the Pin (4) from the Column (2)2.Determine the thread type and length of bolts (not included) needed to thread into the engineblock. Use grade 8 bolts that are long enough to fit through the Arms and thread as deeply aspossible into the engine block.3. Align the Mounting Arms (1) with four mounting bolt locations on the engine.4. Place the bolts (not included) through the Mounting Plate (3) side and securely tighten theminto the engine. The bolt heads must press against the back of the Arms: if needed, use flatwashers (not included) as spacers.5.Tighten the Bolts (5) and its nut that hold the Mounting Arms (1) to the Mounting Plate (3)securely.6.Slowly lower the hoist/engine crane (sold separately) until the entire engine’s weight is held bythe stand.

Upload your study docs or become a

Course Hero member to access this document

Upload your study docs or become a

Course Hero member to access this document

End of preview. Want to read all 83 pages?

Upload your study docs or become a

Course Hero member to access this document

Term
Fall
Professor
NoProfessor
Tags

Newly uploaded documents

Show More

Newly uploaded documents

Show More

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture