C Customize the order and order just the cumulative PTF to remove requisites

C customize the order and order just the cumulative

This preview shows page 52 - 56 out of 64 pages.

C. Customize the order and order just the cumulative PTF to remove requisites and reduce transfer size. D. Order the cumulative in one order, then order the DB2 for IBM i and HIPER groups in a separate order. Answer: A QUESTION: 139 An administrator needs to establish a long-term system performance monitoring process. The administrator needs to show long-term trends in CPU and disk capacity use, with the limits for the processor model on charts. Which tool should the administrator use to support this requirement?
A. IBM i Performance Explorer (PEX) B. IBM System Director Navigator for i C. System i Navigator Management Central D. IBM Performance Management for Power Systems Answer: D QUESTION: 140 Asystem with IBM i 7.1 has at least one lPv6 address configured. When a user tries to ping a remote system by name, the response takes a long time. Ping by IP address (for example 10.x.x.x) works without delay. Which action will fix this problem? A. Usethe command CHGTCPDMN and set the parameter HOSTSCHPTY to *LOCAL. B. Use the command CHGTCPDMN and set the parameter HOSTSCHPTY to *REMOTE. C. Update the Host Table Entries and add a IPv4 for that remote system name. D. Change the ping command default as follows: CHGCMDDFT CMD(PING) NEWDFT(ADRVERFMT(*IP4)) Answer: D QUESTION: 141 An administrator needs to set up and configure a monitor for disk usage under Management Central. Monitors, Based on the image shown, which option is used to set up this monitor?
A. Job B. File C. System D. Message Answer: C QUESTION: 142 A batch job is running a report at priori 50 on a system using IBM defaults for job run priorities. The report results are needed as soon as possible without disrupting interactiveusers. Which run priority value will support the requirement? A. 10 B. 20
C. 40 D. 60 Answer: C QUESTION: 143 What is saved with the SAVSECDTA command? A. User Profiles Group profiles Object owners B. User Profiles Authority Lists PrivateAuthorities C. Authority Lists Primary group profile Object owner assignments D. Private Authorities Group Profiles Primary group profile assignments Answer: B QUESTION: 144 IBM support asks that currently active system firmware level (MHxxxxx) bedeactivated, so the system can run on the older level. How is this accomplished? A. Run command DLTPTF PTE (M) RMV (*TEMP). B. Run the WRKFMWSTS command. Select option 4 on the *TEMP line and press “enter”. C. On the system panel, change the IPL mode to “B” and “P. Then restart the system. D. Run command RMVPTF LICPGM(5770SS1)SELECT(MHxxxxx) DELAYED(*YES),then restart the partition. Answer: C QUESTION: 145 An administrator is working with users to enable them to control printers in their various departments. The required security must enable only control of the departmental printers to users in that department, as well as restricting others from using them. What should the administrator do for each department to support these requirements? A. Changethe output queue “authority to check” parameter to *DTAAUT. Change the *PUBLIC authority for the output queues and devices to *EXCLUDE Grant each user *CHANGE authority to each device description and output queue.

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture