D.This configuration is not supported in a Cisco UCS domain.Correct Answer: CQUESTION 145Which power policy should be chosen to maximize the performance of a Cisco UCS system with fourPSUs and eight blades?A. non-redundantB. N+1C. gridD. performanceCorrect Answer: CQUESTION 146Which Cisco UCS C Series command sequence initiates the sending of a technical support file to a TFTPserver?A.ucs /cimc # scope tech-support ucs /cimc/tech-support # set ip 10.1.1.1 ucs /cimc/tech- support *# settftp-path \showtechsupport ucs /cimc/tech-support *#commit ucs /cimc/tech- support *#startB.ucs /cimc # scope tech-support ucs /cimc/tech-support # set tftp-ip 10.1.1.1 ucs /cimc/tech-support *#set path \showtechsupport ucs /cimc/tech-support *#commit ucs /cimc/tech-support *#startC.ucs /cimc # scope support ucs /cimc/support # set tftp-ip 10.1.1.1 ucs /cimc/support *# set path\showtechsupport ucs /cimc/support *#commit ucs /cimc/support *#startD.ucs /cimc # scope system-support ucs /cimc/system-support # set tftp-ip 10.1.1.1 ucs /cimc/system-support *# set path \showtechsupport ucs /cimc/system-support *#commit ucs /cimc/system-support*#startCorrect Answer: BQUESTION 147Which four tasks can be performed via Cisco IMC remote access to a Cisco UCS system? (Choose four.)A.power cycle the serverB.deploy an operating systemC.toggle the locator LEDD.configure the boot orderE.view properties and sensors
F.configure the hypervisorG.enable Cisco UCS ManagerCorrect Answer: ACDEQUESTION 148During a password recovery of a Cisco UCS system in a cluster configuration, what happens to bladetraffic?A.There is no interruption to traffic, as the fabrics go down one at a time.B.Traffic stops flowing until the process is complete.C.There is no interruption to traffic because both fabrics stay up the whole time.D.Traffic will continue to flow, but at a limited rate until the process is complete.Correct Answer: B
Exam CQUESTION 1Refer to the exhibit.When suspending or deleting VSANs, which three statements are true? (Choose three.)A.You can delete only one VSAN at a time.B.You must wait 60 seconds after you enter the vsan suspend command before you enter anothercommand.C.You must wait 120 seconds after you enter the vsan suspend command before you enter anothercommand.D.You can unsuspend only one VSAN at a time.E.You can delete multiple VSANs as long as they are in the same domain.F.You can delete multiple VSANs as long as they are in the same zone.Correct Answer: ABDQUESTION 2Refer to the output.feature otvotv site-vlan 2otv site-identifier 256!interface ethernet 2/0ip address 192.0.2.1/24ip igmp version 3!interface ethernet 2/1ip address 192.0.2.2/24ip igmp version 3!interface Overlay1otv control-group 126.96.36.199
otv join-interface ethernet 2/0otv extend-vlan 3-100!interface Overlay2otv control-group 188.8.131.52otv join-interface ethernet 2/1otv extend-vlan 101-115Which command best represents where the control plane configurations are applied?