{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

Physics Lab write up 7

# Allow the free mass some room to move within the slot

This preview shows pages 1–3. Sign up to view the full content.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Force_mass SW, then they must find the total mass of their weight. Enter that value in kilograms ( so mass (g)/1000) into the force vs. Mass data table in DataStudio. To add mass to either of the arms, lay the components over the attachment screw in the following order: i) cable ii) mass and iii) thumbscrew. Next allow the “free mass” to move(slide) within the slot. To avoid wobbling place an equal amount of mass on both the “fixed mass” arm and the “free mass” arm. Once again the student must make sure that the “free mass” and “fixed mass” have the same radius so the motor will be balanced when rotating. Then turn on the power supply and adjust the voltage from 0 to 5 volts. Observe the vertical section of cable. If it is not completely vertical, student should adjust the horizontal rod. Then turn the power supply down to 0V.
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 4

Allow the free mass some room to move within the slot...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online