Figure sacristy daytime working plane isolines figure

Figure ## Sacristy – Daytime – Working Plane
– Isolines
Figure ## Sacristy – Daytime – Working Plane
– False Colors
Figure ## Sacristy – Daytime – Working Plane
– Value Chart
Figure ## Display Control Room – Daytime with
All Luminaire Groups Off – Working Plane –
Combined Data
When simulated under similar conditions except
that no luminaires were turned on, the room was only
able to achieve 236 lux which is below the standard
of 300 lux. Therefore, there is a need for luminaires
to be turned on during the day. Although large
amount of sunlight enters the room through the
windows, it is not enough to light the entire room up
to the standard levels. At the center of the room,
values of only 40 to 90 lux were observed which
greatly improved to between 260 and 330 lux when
luminaire group three was turned on. Areas near the
front doors were also lower ranging from 70 to 90
lux and greatly improved to between 160 to 250 lux.
ii. Floor Plane
Figure ## Sacristy – Daytime – Floor Plane –
Combined Data 1
Figure ## Sacristy – Daytime – Floor Plane –
Combined Data 2

UST: EE524L-T2AY1920-5EEB-G6 15
The room floor plane was able to reach an average level
of 174 lux. Although below standard, it was observed that the
walking areas were able to reach levels of 200 to 300 lux
which is ample enough for walking and avoid hitting
something. Uniformity can also be observed withing the
walking areas so the eyes will not get tired with adjusting
when walking.
Figure ## Sacristy – Daytime – Floor Plane –
Isolines
Figure ## Sacristy – Daytime – Floor Plane –
False Colors
Figure ## Sacristy– Daytime – Floor Plane –
Value Chart
Figure ## Display Control Room – Daytime with
All Luminaire Groups Off – Floor Plane –
Combined Data
Similar to the working plane, lower values were observed
when all the luminaire groups were turned off which can
result to uncomfortable walking and eye strain as the eyes are
trying to see what is there in the vicinity of your walking area.
d. Nighttime Data
Figure ## Sacristy – Nighttime – 3D Render 1
Figure ## Sacristy – Nighttime – 3D Render 2
Figure ## Sacristy – Nighttime – Room – False
Color 1
Figure ## Sacristy – Nighttime – Room – False
Color 2
i. Working Plane

UST: EE524L-T2AY1920-5EEB-G6 16
Figure ## Sacristy – Nighttime – Working Plane
– Combined Data 1
Figure ## Sacristy – Nighttime – Working Plane
– Combined Data 2
Nighttime was simulated at 8:00 PM as usually the last
mass ends at this time and the sun is completely out. The room
was still able to reach an average value of 311 lux which
means the room was able to reach the standards with its
luminaires. Empty areas were able to achieve values of more
than 400 lux as they area directly below luminaires five and
six which has the greatest luminous flux. Values were then
gradually decreasing to the standard of around 300 lux at the
center area where most activities were made during the night
such as preparing for the mass and where the couches are
located for resting.