DTC B163023 is recorded when a malfunction is detected in the rear airbag

Dtc b163023 is recorded when a malfunction is

This preview shows page 64 - 68 out of 381 pages.

DTC B1630/23 is recorded when a malfunction is detected in the rear airbag sensor LH circuit. WIRING DIAGRAM DTC B1630/23 Driver Side Rear Airbag Sensor Circuit Mal- function DTC No. DTC Detection Condition Trouble Area B1630/23 The center airbag sensor assembly receives a line short signal, open signal, short to ground signal or B+ short signal in the rear airbag sensor LH circuit for 2 seconds. Rear airbag sensor LH malfunction Center airbag sensor assembly malfunction Rear airbag sensor LH Center airbag sensor assembly Floor wire Center Airbag Sensor Assembly A11 A11 20 22 W 2 1 B A18 Rear Airbag Sensor LH VUCL ESCL VUCD ESCD H041710E31
Image of page 64
SUPPLEMENTAL RESTRAINT SYSTEM AIRBAG SYSTEM RS–65 RS INSPECTION PROCEDURE (a) Turn the ignition switch to the ON position, and wait for at least 60 seconds. (b) Clear the DTCs stored in memory (see page RS-18 ). (c) Turn the ignition switch to the LOCK position. (d) Turn the ignition switch to the ON position, and wait for at least 60 seconds. (e) Check for DTCs (see page RS-18 ). OK: DTC B1630/23 is not output. HINT: Codes other than code B1630/23 may be output at this time, but they are not related to this check. NG OK (a) Turn the ignition switch to the LOCK position. (b) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds. (c) Check that the connectors are properly connected to the center airbag sensor and the rear airbag sensor LH. OK: The connectors are connected. NG OK 1 CHECK FOR DTC Center Airbag Sensor Assembly Rear Airbag Sensor LH H045269E01 Go to step 2 PERFORM SYMPTOM SIMULATION 2 CHECK CONNECTION OF CONNECTORS CONNECT CONNECTORS
Image of page 65