Question why is the login command required without

This preview shows page 5 - 8 out of 11 pages.

Question: Why is the login command required? __without the login command input, the switch will never prompt for the password needed.________________ Type your answers here. Close configuration window © 2013 - 2019 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 5 of 11
Lab - Basic Switch Configuration Step 2: Configure an IP address on PC-A. Assign the IP address and subnet mask to the PC as shown in the Addressing Table. An abbreviated version of the procedure is described here. A default gateway is not required for this topology; however, you can enter 192.168.1.1 and fe80::1 to simulate a router attached to S1. 1) Navigate to the Control Panel . 2) In the Category view, select View network status and tasks . 3) Click Change adapter settings on the left panel. 4) Right-click an Ethernet interface, and choose Properties . 5) Choose Internet Protocol Version 4 (TCP/IPv4) and click Properties . 6) Click the Use the following IP address radio button and enter the IP address and subnet mask and click OK . 7) Select Internet Protocol Version 6 (TCP/IPv6) and click Properties . 8) Click the Use the following IPv6 address radio button and enter the IPv6 address and prefix and click OK to continue 9) Click OK to exit the Properties window. Part 3: Verify and Test Network Connectivity In Part 3, you will verify and document the switch configuration, test end-to-end connectivity between PC-A and S1, and test the switch’s remote management capability. Step 1: Display the switch configuration. Use the console connection on PC-A to display and verify the switch configuration. The show run command displays the entire running configuration, one page at a time. Use the spacebar to advance paging. a. A sample configuration is shown here. The settings you configured are highlighted in yellow. The other Open configuration window configuration settings are IOS defaults. S1# show run Building configuration... Current configuration : 2206 bytes ! version 15.2 no service pad service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname S1 ! boot-start-marker boot-end-marker ! enable secret 5 $1$mtvC$6NC.1VKr3p6bj7YGE.jNg0 ! no aaa new-model system mtu routing 1500 ! ! no ip domain-lookup ! <output omitted> ! interface FastEthernet0/24 switchport access vlan 99 ! interface GigabitEthernet0/1 switchport access vlan 99 ! © 2013 - 2019 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 6 of 11
Lab - Basic Switch Configuration interface GigabitEthernet0/2 switchport access vlan 99 ! interface Vlan1 no ip address no ip route-cache ! interface Vlan99 ip address 192.168.1.2 255.255.255.0 ipv6 address FE80::2 link-local ipv6 address 2001:DB8:ACAD::2/64 ! ip default-gateway 192.168.1.1 ip http server ip http secure-server ! banner motd ^C Unauthorized access is strictly prohibited. ^C ! line con 0 password 7 00071A150754 logging synchronous login line vty 0 4 password 7 121A0C041104 login line vty 5 15 password 7 121A0C041104 login !

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture