Hpe employee copy module 4lab 4 secure wlan

  • No School
  • AA 1
  • MinisterMask10583
  • 147
  • 100% (4) 4 out of 4 people found this document helpful

This preview shows page 45 - 51 out of 147 pages.

HPE Employee Copy
Image of page 45
Module 4—Lab 4: Secure WLAN Configuration 38 Confidential – For Training Purposes Only IMPORTANT: Don’t forget to commit your configuration by clicking on Pending Changes, on the top right-hand side. This ensures that your configuration is applied, validated, and pushed down the hierarchy group/subgroups. Task 2: Configuring Secure WLAN Using Wizards In this task you will configure an employee WLAN using the WLAN wizards. MM (Mobility Master) 1. Navigate to Managed Network ->Configuration -> Tasks -> Create a New WLAN. HPE Employee Copy
Image of page 46
Module 4—Lab 4: Secure WLAN Configuration 39 Confidential – For Training Purposes Only 2.The New WLAN window has four steps - General, VLANs, Security, and Access. Each step re in the wizard requires you to input or choose appropriate options. In the New WLAN’s General window, enter the following options. a.Name (SSID): p#-employeeX(#= your POD number and X= Your Table number)b.Primary usage: Employeec.Broadcast on: from drop-down Select AP Groupsand uncheck defaultand check apgroup-X(X= Your Table number)d.Forwarding mode: Tunnele.Broadcast SSID: Yesf.Then click Next at the bottom right-hand side. 3. In the VLANs window, choose your employee VLAN, emp-vlanX1, from the drop-down. ( X= Your Table number). Then click Next . HPE Employee Copy
Image of page 47
Module 4—Lab 4: Secure WLAN Configuration 40 Confidential – For Training Purposes Only 4.In the Security window, enter the following options: a.More Secure: Personalb.Key management: WPA2-Personal c.Passphrase: aruba123d.Retry:aruba123 e.Leave other options at default values. Click Next5.In the Access window, choose the Authenticated role from the drop-down. Click Finish. . HPE Employee Copy
Image of page 48
Module 4—Lab 4: Secure WLAN Configuration 41 Confidential – For Training Purposes Only 6. To commit your configuration, click Pending Changes at the top right-hand side. You will see the Pending Changes window. Click the checkboxes, then click Deploy Changes, and you will see the Configuration Deployment Status window. Click Close. HPE Employee Copy
Image of page 49