whether the AP has detected a rogue AP E whether a software upgrade is in

Whether the ap has detected a rogue ap e whether a

This preview shows page 3 - 5 out of 6 pages.

D. whether the AP has detected a rogue AP E. whether a software upgrade is in process Answer: B, C Explanation: The Power LED shows if the AP is receiving power. If the Power LED is blinking, the AP is starting up. If it continues to blink after several minutes, the software failed to load. Try Resetting or power cycling the AP. The Ethernet LED shows if data is being sent or received through the Ethernet port. The LED is off if there is no activity, or blinking if activity is present. QUESTION: 80 You are resetting an HP E Series AP to factory defaults using its reset button. How many times should the LEDs blink before you release the button? A. once B. twice C. three times D. four times Answer: C Explanation: To reset the device to factory defaults, press and hold the reset button until all LEDs blink three times, and then release the button. QUESTION: 81 Which device requires switch CLI access for initial configuration? A. E-MSM317 Access Device B. E-MSM415 RF Security Sensor C. E-MSM422 Access Point D. E-MSM765zl Mobility Controller 38
Image of page 3
Answer: D Explanation: Unlike the E-MSM710 and E-MSM760, the HP E-MSM765 zl has no factory-default LAN port IP address. You will need to assign its LAN port an IP address before you can access the controller through the Web browser interface. QUESTION: 82 A customer wants you to install a 9-Port 10/100 PoE DSIC in an HP A-MSR 50 Series router.
Image of page 4
Image of page 5

You've reached the end of your free preview.

Want to read all 6 pages?

  • Fall '20
  • AP, Wireless access point

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture