Question why is the login command required the log in

  • Liberty University
  • CSIS MISC
  • ConstableFogTurtle172
  • 12
  • 100% (2) 2 out of 2 people found this document helpful

This preview shows page 5 - 8 out of 12 pages.

Question: Why is the logincommand required? _____The log in command adds a layer of security and is requiredfor access._____________Type your answers here. Close configuration window Step 2: Configure an IP address on PC-A. Assign the IP address and subnet mask to the PC as shown in the Addressing Table. An abbreviated versionof the procedure is described here. A default gateway is not required for this topology; however, you can enter192.168.1.1and fe80::1to simulate a router attached to S1. 1)Navigate to the Control Panel. 2)In the Category view, select View network status and tasks. 3)Click Change adapter settingson the left panel. 4)Right-click an Ethernetinterface, and choose Properties. 5)Choose Internet Protocol Version 4 (TCP/IPv4)and click Properties. ©2013 - 2019 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 5of 12
Lab - Basic Switch Configuration 6)Click the Use the following IP addressradio button and enter the IP address and subnet mask andclick OK. 7)Select Internet Protocol Version 6 (TCP/IPv6)and click Properties. 8)Click the Use the following IPv6 addressradio button and enter the IPv6 address and prefix andclick OKto continue 9)Click OKto exit the Properties window. Part 3: Verify and Test Network Connectivity In Part 3, you will verify and document the switch configuration, test end-to-end connectivity between PC-Aand S1, and test the switch’s remote management capability. Step 1: Display the switch configuration. Use the console connection on PC-A to display and verify the switch configuration. The show runcommanddisplays the entire running configuration, one page at a time. Use the spacebar to advance paging.a. A sample configuration is shown here. The settings you configured are highlighted in yellow. The other Open configuration windowconfiguration settings are IOS defaults.S1# show runBuilding configuration... Current configuration : 2206 bytes !version 15.2 no service pad servicetimestampsdebugdatetimemsecservice timestamps log datetime msecservice password-encryption ! hostname S1 !boot-start-marker boot-end-marker! enable secret 5 $1$mtvC$6NC.1VKr3p6bj7YGE.jNg0 !no aaa new-model systemmtu routing 1500 ! ! no ip domain-lookup! <output omitted>! interface FastEthernet0/24 switchport access vlan 99 ! interface GigabitEthernet0/1switchport access vlan 99 ! interface GigabitEthernet0/2switchport access vlan 99 ! interfaceVlan1no ip address noip route-cache ! interfaceVlan99 ipaddress192.168.1.2 255.255.255.0 !ipdefault-gateway 192.168.1.1 ip httpserver ip http secure-server ! banner motd ^C Unauthorized access is strictly prohibited. ^C !©2013 - 2019 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 6of 12
Lab - Basic Switch Configuration line con 0 password 700071A150754 loggingsynchronous login linevty 0 4 password 7121A0C041104 loginline vty 5 15 password7 121A0C041104 login !end b.Verify the management VLAN 99 settings.

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture