85%(34)29 out of 34 people found this document helpful
This preview shows page 9 - 10 out of 10 pages.
87._________________ is a strategy for correcting resource overallocations. Page: 138 LOD: Easy 88.A project is considered ______________________ if, (1) the resulting information system is acceptable to the customer; (2) the system was delivered on time; (3) the system was within budget; and (4) the system development process had a minimal impact on ongoing business operations. Page: 121 LOD: Medium 89.A ________________________ is a simple horizontal bar chart that depicts project tasks against a calendar. Page: 125 LOD: Easy 90._____________________ defines the boundaries of a project. Answer: Scope Page: 130 LOD: Medium 91.________________________ identifies the required tasks to complete the project based on the project goal. Answer: Planning Page: 124 LOD: Medium 92.A _____________________________ must demonstrate people management skills to coordinate, delegate, motivate, advise, appraise, and reward team members. Page: 125 LOD: Medium 93.PERT charts were developed to make clear the _____________________ between project tasks before those tasks are scheduled. Page: 125 LOD: Medium Whitten/Bentley, Systems Analysis & Design Methods, Seventh Edition62
Chapter 4 Project Management94.____________________________ is a strategy wherein all project stakeholders participate in a short duration project management workshop, which results in a consensus agreement on the project scope, schedule, resources, and budget. Page: 127 LOD: Hard 95._______________________________ is the estimated minimum amount of time needed to complete a task. Page: 133 LOD: Hard 96.________________________ measures the actual amount of time that it takes to complete a task, taking into account that workers cannot possibly perform at 100% efficiency, and that interruptions increases the amount of time it takes from start to finish to complete a task. Page: 133 LOD: Medium 97.The __________________________________ is the sequence of dependent tasks thatdetermines the largest sum of most likely durations. Page: 138 LOD: Medium 98.The ____________________________________ available for any non-critical task is the amount of delay that can be tolerated between the starting time and completion time of a task without causing a delay in the completion date of the entire project. Page: 138 LOD: Medium 99.Give some reasons for project changes. Page: 142 LOD: Hard 100.A(n) __________________________________________ is a tool for helping management understand the dynamics and impact of changing project parameters suchas cost, schedule, scope and quality. Page: 143 LOD: Medium 63Whitten/Bentley, Systems Analysis & Design Methods, Seventh Edition