Add the new disks to the vsan datastore you receive

This preview shows page 23 - 27 out of 28 pages.

add the new disks to the vSAN datastore you receive an error message about there being no cache tier available. What is the likely cause? A. vSAN supports disk groups with four drives or fewer B. Cluster requires vSAN Advanced or Enterprise license upgrade C. You attempted to add the disks to the existing disk group D. All the drives are labeled as HDDs
您正在通過創建額外的磁盤組來擴展混合 VxRail 的容量。
新磁盤組將由所有參與群集節點上的五個驅動器組成。 當您嘗試將新磁盤添加到 vSAN 數據存儲時,您會收到一條關於沒有可用緩存層的錯誤消息。 What action is required to enable VxRail Manager the ability to update system software and browse VxRail KB articles?
How does the Network Validation Tool (NVT) validate Top of Rack (ToR) switch configurations?
A Stretched VxRail cluster is being designed with four nodes per site, for a total of eight nodes. How many sites are required for this configuration?
When resetting a Dell PowerEdge-based VxRail node to an existing factory image, which boot device should be selected? A. BOSS B. RASRUSB C. SATADOM D. IDSDM Rapid Appliance Self Recovery (RASR) images are retained on the Dell Internal Dual SD Module (IDSDM) on all VxRail models. This allows RASR to restore the system back to factory state after an irrecoverable failure Generate the Rapid Appliance Self-Recovery (RASR) Factory Image Upgrade Procedure (Dell platforms only). Follow the steps in the procedure to create a RASR USB. Then boot into the RASR USB to upgrade the Factory Image on the VxRail node SD card from the RASR USB should be B
What is a requirement for Top-of-Rack (ToR) switches when deploying a VxRail cluster? A. Must be manufactured by Dell, Cisco, or Brocade B. Must support IPv6 Multicast C. Must have two switches in the cluster D. Must support 25GbE connectivity
In which VxRail node model is the iDRAC ג €˜ NIC Selection Setting ג €™ set to LOM1?
What VxRail model is designed to support graphic intensive VDI workloads?
During the installation of a new VxRail cluster, where is System Time configured ?
Which service determines the primary node after powering on Dell PowerEdge-based VxRail nodes during the deployment of a VxRail Appliance?

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture