Leave it in that position for at least 5 seconds

Leave it in that position for at least 5 seconds.
Change the panel mode switch to Service, and press return...
XSCF>
Settings Command
Registration of an XSCF user account, password, and user privileges
Registration of a user account of a field engineer (FE) (for maintenance)
adduser , password ,
setprivileges
Date and time settings setdate , settimezone
Confirmation of the XSCF host public key showssh
SSH/telnet settings setssh , settelnet
Network interface, routing, and DNS-related settings
*
* To apply the settings, the XSCF unit must be reset with the applynetwork and rebootxscf commands.
setnetwork,setroute ,
setnameserver etc.
Domain-SP Communication Protocol (DSCP) settings
†
† To apply the settings, the XSCF unit must be reset with the rebootxscf commands.
Altitude administration setting
‡
‡ To apply changes made with the setdualpowerfeed command, power to the server must be completely disconnected and then
reconnected (all power cords must be disconnected and then reconnected). Wait at least 30 seconds before reconnecting the power cords to
the server.
setaltitude
Dual power feed option setting setdualpowerfeed
XSCF> console -d 0
Connect to DomainID 0?[y|n] : y

5
d. Push the Power button ( ) on the operator panel to power on the server.
The server starts and begins a self-diagnosis. Confirm that no error messages are displayed on the
administration console during the boot process.
e. Confirm that the POWER LED ( ) on the operator panel is turned on.
f. Confirm that ok prompt is displayed on the domain console.
The ok prompt is displayed after the self-diagnosis completes.
g. Press the Enter key, and then press the "#" and “.”(period) keys.
This switches you from the domain console to the XSCF Shell.
h. From the XSCF Shell, execute the fmdump command or showlogs command, and confirm that no
errors are found.
2. Connect the system control network to a LAN port (see
FIGURE 1
, #4) on the rear panel of the server with
an Ethernet cable.
3. Verify the hardware configuration by using the following commands on the administration console
connected to the system control network.
To switch from the XSCF console to the ok prompt, enter the console -d 0 command. To switch from the
ok prompt to the XSCF console, press the enter key, and then press the "#" and "." (period) keys.
4. Install additional hardware or peripheral devices. If not needed, proceed to the Step 5 .
For details on how to add optional devices, such as additional memory or an additional PCIe card, see the
SPARC Enterprise M3000 Server Service Manual . To add an additional storage device or other peripheral
device, see the manual supplied with the device.
5. The following steps will connect the domain to the user network. If you isolate the domain from the
network, proceed to the Step 1 .