141-2 Part 2
Internal gas pressure cables and accessories
for alternating voltages up to and including
275 kV
141-3 Part 3
External gas pressure (gas compression)
cables and accessories for alternating
voltages up to 275 kV
141-4 Part 4
Oil-impregnated paper-insulated high-
PE4| Christian L. Ranada
UNIVERSITY OF SANTO TOMAS
FACULTY OF ENGINEERING
España, Manila
pressure oil-filled pipe-type cables and
accessories for alternating voltages up to
and including 400 kV
IEC 229
Tests on cable over sheaths which have a special protective
function and are applied by extrusion
IEC 230
Impulse tests on cables and their accessories
IEC 332
Tests on electric cables under fire conditions
332-1 Part 1
Test in a single vertical insulated copper wire
of cable
332-2 Part 2
Test on a single small vertical insulated
copper wire or cable
332-2 Part 3
Tests on bunched wires or cables
IEC 538
Electric cables, wires, and cords: methods of test for
polyethylene insulation and sheath
IEC 540
Test methods for insulation and sheaths of electric cables and
cords (elastomeric and thermoplastic compounds)
IEC 754
Test on gases evolved during combustion of electric cables
754-1 Part 1
Determination of the amount of halogen acid
gas evolved during the combustion of
polymeric materials taken from cables
754-2 Part 2
Determination of degree of acidity of gases
evolved during the combustion of materials
taken from electric cables by measuring pH
and conductivity
IEC 811
Common test methods for insulating and sheathing materials of
electric cables
811-1 Part 1
Methods for general application
811-2 Part 2
Methods specific to elastomeric compounds
811-4 Part 4
Methods specific to polyethylene and
polypropylene compounds
811-5 Part 5
Methods specific to filling compounds
IEC 840
Tests for power cables with extruded insulation for rated
voltages above 30kV (U = 36 kV) up to 150 kV (U = 170 kV)
IEC 885
Electrical test methods for electric cables
885-1 Part 1
Electrical tests for cables, cords and wires
for voltages up to and including 450/750 V
885-2 Part 2
Partial discharge tests
885-3 Part 3
Test methods for partial discharge
measurements on lengths of extruded power
cables
IEC 1034
Measurement of smoke density of electric cables burning under
defined conditions
1034-1 Part 1
Test apparatus
1034-2 Part 2
Test procedures and requirements
Jointing and Accessories
IEC 702
Similar to BS 6121. Mechanical cable glands
Part 1: 1989
Metallic glands
Part 2: 1989
Polymeric glands
PE4| Christian L. Ranada
UNIVERSITY OF SANTO TOMAS
FACULTY OF ENGINEERING
España, Manila
Part 2: 1990
Special corrosion resistant glands
Part 5: 1992
Code or practice for selection, installation
and inspection of cable glands used in
electrical installations
Miscellaneous
IEC 38
IEC standard voltages
IEC 71
Insulation co-ordination
71-1 Part 1
Terms, definitions, principles, and rules
71-2 Part 2
Application guide
71-3 Part 3
Phase-to-phase insulation co-ordination:
principles, rules, and application guide
IEC 183
Guide to the selection of high voltage cables
IEC 287
Calculation of the continuous current rating of cables (100%
load factor)
IEC 331
