The standard Ethernet frame length should not be less than 64 bytes Which of

The standard ethernet frame length should not be less

This preview shows page 3 - 5 out of 8 pages.

Question: 5 The standard Ethernet frame length should not be less than 64 bytes. Which of the following factors cause this limitation? (Multiple Choice) A. Minimum transmission distance B. Maximum transmission distance C. Working mechanism of conflict detection D. MAC address Answer: BC Question: 6 The device IP addresses of the gateway NE and non-gateway NEs must be set in the same network segment. Question: 7 Which of the following are the service board types of MSTP devices? (Multiple Choice) Answer: ABC Question: 8 Visit us athttps://
Image of page 3
When the LCAS function is used/ which of the following overhead bytes are used to transmit control information? (Multiple Choice) Question: 9 Which of the following are the electrical-layer overheads of OTN? (Multiple Choice) A. OPUk B. ODUk C. OCh D. OTUk Answer: ABD Question: 10 The working mode of a port determines the flow control mode of the port. When the working mode is 100 Mbit/s full duplex, which of the following flow control modes can be used?
Image of page 4
Image of page 5

You've reached the end of your free preview.

Want to read all 8 pages?

  • Spring '13
  • oovoo
  • Accounting, MAC address, Multiplexing, Wavelength-division multiplexing

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture