Version d1 4 11 an5116 06b optical line terminal

This preview shows page 61 - 66 out of 152 pages.

Version: D/1 4-11
Image of page 61
AN5116-06B Optical Line Terminal Equipment Installation Guide 5. Follow Step 2 and Step 3 to remove the wooden panels on the sides of the box in the same way, as shown in Figure 4-3. Figure 4-3 Removing Wooden Side Panels 6. Carry the cabinet out with two to four people and move it to the specified position. Wear the ESD protection glove to remove the ESD protection plastic bag, and make the cabinet stand up stably. 4.4.3 Unpacking the Carton Cartons are usually used to pack small goods such as the cards, accessories or small terminal devices. The paragraphs below introduce how to unpack the carton using the unpacking of a carton containing a card box as an example. Prerequisite The external package has been inspected visually and verified to be satisfactory. Tools and Instruments u A paper knife u A pair of gloves 4-12 Version: D/1
Image of page 62
4 Installation Preparation Procedure See Figure 4-4 for procedures of unpacking a carton. (1) Carton (2) Card box label (3) Card box Figure 4-4 Unpacking a Carton 1. Wear the gloves or take other protection measures. 2. Lay the carton stably on the ground with the right side up. 3. Use the paper knife to cut the adhesive tape on the seam of the carton lightly; and then open the carton. Caution: When cutting the adhesive tape, do not cut too deep into the box, making sure that you cut only the tape without damaging the article inside the box. 4. Make sure that the package of the card box in the carton is intact, and then take out the card box. Version: D/1 4-13
Image of page 63
AN5116-06B Optical Line Terminal Equipment Installation Guide 4.4.4 Unpacking a Card Note: 1. The card is packed in the ESD protection bag. Do not remove the card from the protection bag before you are ready to install the card. 2. When a card is moved from a cold and dry place to a hot and damp place, users must wait at least 30 minutes before unpacking. Otherwise, humid air may condense on the surface of the card and damage the card. Prerequisite u The external package of the card box has been inspected and verified to be satisfactory. u The installers should keep both their hands clean and dry. Tools and Instruments u A paper knife u A pair of gloves u A pair of ESD protection gloves Procedure Figure 4-5 shows the procedure of unpacking a card. 4-14 Version: D/1
Image of page 64
4 Installation Preparation (1) Card box (2) Inflatable packaging cushion (3) to (5) Shakeproof foam (6) ESD protection bag (7) Card Figure 4-5 Unpacking a Card 1. Wear the gloves or take other protection measures. 2. Lay the card box stably on the ground with the right side up. 3. Cut the adhesive tape on the seam of the box and then unpack the card. Caution: When cutting the adhesive tape, do not cut too deep into the carton, making sure that you cut only the tape without damaging the goods inside the carton.
Image of page 65
Image of page 66

You've reached the end of your free preview.

Want to read all 152 pages?

  • Fall '19

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture