Fill the buret a little above the 000 ml level of the

This preview shows page 2 - 3 out of 3 pages.

buret to the ring stand as shown in Figure 1. Fill the buret a little above the 0.00 mL level of the buret with 0.050 M NaOH solution. Drain a small amount of NaOH solution so it fills the buret tip andleaves the NaOH at the 0.00 mL level of the buret. Record the precise concentration of the NaOH solution in your data table.Figure 17.You are now ready to perform the titration. This process goes faster if one person manipulates and reads the buret while another person operates the handheld and enters volumes.a.Start data collection. b.Before you have added any NaOH solution, click and enter 0as the buret volume in mL. Click to store the first data pair for this experiment. c.Add 0.5 mL of NaOH solution. When the pH stabilizes, click and enter the current buret reading in mL. Click .You have now saved the second data pair for the experiment.d.Continue to add 0.5 mL increments, entering the buret level after each increment. When the pH has leveled off (near pH 10), click to end data collection.8.Examine the data on the graph of pH vs.volume to find the equivalence point—that is, the 0.5 mL volume increment that resulted in the largest increase in pH. As you move the examine line, the pH and volume values of each data point are displayed to the right of the graph. Go to the region of the graph with the large increase in pH. Find the NaOH volume (in mL) just beforethis jump. Record this value in the data table. Then record the NaOH volume after

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture