A Diff B Dump C Show D Config Answer A QUESTION 147 Which Cisco Catalyst Blade

A diff b dump c show d config answer a question 147

This preview shows page 3 - 5 out of 6 pages.

A. Diff B. Dump C. Show D. Config Answer: A QUESTION: 147 Which Cisco Catalyst Blade Switch 3020 ports must be manually enabled for the crosslink communication to function between two switches installed in the horizontal bays of the c7000 enclosure? A. 7 and 8 B. 17 and 18 C. 19 and 21 D. 23 and 24 Answer: D QUESTION: 148 46
Image of page 3
Which conditions must be met for the Cisco Catalyst Blade Switch 3020 to automatically receive an IP address for its fa0 interface from the Onboard Administrator? (Select three.) A. The switch VLAN 1 IP address must be assigned. B. The enclosure must be powered on when installing the switch. C. The basic Onboard Administrator configuration must be completed. D. One of the switch uplinks must be connected to a network with a DHCP server. E. A DHCP server must exist on the network accessible by the Onboard Administrator. F. The Mode button must be pressed and held immediately after installing the switch in the enclosure. Answer: B, C, E QUESTION: 149 What is the maximum number of Virtual Connect - Ethernet modules that can be installed in the c7000 enclosure?
Image of page 4
Image of page 5

You've reached the end of your free preview.

Want to read all 6 pages?

  • Fall '20
  • IP address, Dynamic Host Configuration Protocol, Onboard Administrator

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture