Lab - Basic Switch Configuration
Why is the
Type your answers here.
Close configuration window
Step 2: Configure an IP address on PC-A.
Assign the IP address and subnet mask to the PC as shown in the Addressing Table. An abbreviated
version of the procedure is described here. A default gateway is not required for this topology;
however, you can enter
to simulate a router attached to S1.
Navigate to the
In the Category view, select
View network status and tasks
Change adapter settings
on the left panel.
interface, and choose
Internet Protocol Version 4 (TCP/IPv4)
Use the following IP address
radio button and enter the IP address and subnet
mask and click
Internet Protocol Version 6 (TCP/IPv6)
Use the following IPv6 address
radio button and enter the IPv6 address and prefix
to exit the Properties window.
Part 3: Verify and Test Network Connectivity
In Part 3, you will verify and document the switch configuration, test end-to-end connectivity
between PC-A and S1, and test the switch’s remote management capability.
Step 1: Display the switch configuration.
Use the console connection on PC-A to display and verify the switch configuration. The
command displays the entire running configuration, one page at a time. Use the spacebar to advance
a. A sample configuration is shown here. The settings you configured are highlighted in yellow. The
Open configuration window
configuration settings are IOS defaults.
Current configuration : 2206 bytes !
version 15.2 no service pad service
timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption !
hostname S1 !
enable secret 5 $1$mtvC$6NC.1VKr3p6bj7YGE.jNg0 !
no aaa new-model
system mtu routing
1500 ! !
2013 - 2019 Cisco and/or its affiliates. All rights reserved. Cisco Public