Question 387 when executing the following show mpls

This preview shows page 5 - 8 out of 10 pages.

QUESTION: 387 When executing the following show mpls l2transport vc detail command, you notice the link does not come up. Choose the most likely cause. PE#sho mpls l2transport vc detail Local interface: Et0/0 up, line protocol up, Ethernet up Destination address: 172.168.1.102, VC ID: 100, VC status: down Preferred path: not configured Default path: active Tunnel label: 16, next hop point2point Output interface: Se5/0, imposed label stack {16 16} Create time: 00:18:10, last status change time: 00:03:51 Signaling protocol: LDP, peer 172.168.1.102:0 up MPLS VC labels: local 16, remote 16 Group ID: local 0, remote 0 141
MTU: local 1500, remote unknown Remote interface description: Sequencing: receive disabled, send disabled VC statistics: packet totals: receive 0, send 0 byte totals: receive 0, send 0 packet drops: receive 0, send 78
QUESTION: 388 In a Distance Vector protocol, "counting to infinity":
QUESTION: 389 What command should you use to modify MTUs on a 3550 switch?
QUESTION: 390 CIDR is primarily used: A. In BGP only B. For classless routing
142
C. In OSPF only D. In EIGRP only Answer: B

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture