The next step done was to determine how accurate and

This preview shows page 3 - 6 out of 8 pages.

same steps as the 50mL and 125mL beakers using the same electronic scale. The next step done was to determine how accurate and precise a 10mL graduated cylinder was. Following all those same steps you were to determine the mass of the water in the glassware then calculate the volume, from there you can figure out your experimental density and the percent error. Lastly wewere to determine the mass of sand by weighing out exactly one gram, if you didn’t take the exact mass using the scoopula you could have added or subtracted sand from the weigh boat. Finally clean up, place distilled water down the sink, pour the sand into the correct waste bucket and properly store your glassware.
Results:Table 1: Glassware ResultsTrialMass empty (g)Mass full (g)Water Mass (g)Water Volume (mL)Density (g/mL)Ave. Density (g/mL)Ave. % Error50mL Beaker129.992g52.103g22.111g20.0mL11.1g/mL1.03g/mL2.96%230.015g50.490g20.475g20.0mL1.02g/mL329.990g49.047g19.048g20.0mL0.952g/mL100mL Beaker170.523g100.492g29.969g40.0mL0.749g/mL0.756g/mL24.23%270.518g101.470g30.952g40.0mL0.774g/mL370.523g100.310g29.787g40.0mL0.745g/mL125mL ErlenmeyerFlask198.172g141.713g43.541g50.0mL0.871g/mL0.819g/mL17.92%298.485g139.575g41.090g50.0mL0.822g/mL398.534g136.676g38.142g50.0mL0.763g/mL10mL GraduatedCylinder125.945g26.003g0.0580g1.0mL0.06g/mL0.06g/mL94.11%225.955g26.013g0.0580g1.0mL0.06g/mL325.952g26.006g0.0540g1.0mL0.05g/mL50mL Buret128.659g39.132g10.473g10.0mL1.05g/mL1.02g/mL1.75%228.664g38.626g9.9620g10.0mL0.996g/mL328.653g38.671g10.018g10.0mL1.00g/mL
Table 2: Sand ResultsTable R2Using “TARE”Without using “TARE”Trial 11.000g1.073gTrial 21.000g1.064gTrial 31.000g1.027gThe mass of the water was acquired by subtracting the mass of the empty container from themass of the full container.

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture