drc6dK01netbackup etcinitdnetbackup Linux SUSE etcrc0dK01netbackup

Drc6dk01netbackup etcinitdnetbackup linux suse

This preview shows page 118 - 120 out of 159 pages.

/etc/init.d/rc6.d/K01netbackup ->/etc/init.d/netbackup Linux SUSE /etc/rc0.d/K01netbackup ->/etc/init.d/netbackup /etc/rc1.d/K01netbackup ->/etc/init.d/netbackup /etc/rc2.d/S77netbackup ->/etc/init.d/netbackup Solaris About NetBackup server configuration After all server software is installed, you are ready to configure NetBackup to work with the robotic and the storage devices in your environment. Remember the operating system must recognize these devices as configured before you can configure them in NetBackup. See “About storage device configuration” on page 17. Use the following guidelines when you configure NetBackup: 118 Configuring NetBackup About NetBackup server configuration
The procedures for configuring master and media servers are very similar. Veritas recommends, however, that you configure all server information such as storage devices and volumes from the master server. Following this order helps ensure that the master servers properly administer the media servers. Warning: Communication problems between the master server and the media server do not prevent you from running the configuration wizards. Therefore, do not run the wizards on the media server until the problems are corrected. If you run any of the wizards when a communication problem exists, the master server cannot recognize the information that you enter. You must first correct the problem. After you correct the problem, run the configuration wizards from the master server. NetBackup Enterprise servers Configure devices on every node in the cluster. Start by configuring all storage devices from the active node so that they work with NetBackup. For a NetBackup failover server, attach all of the devices to each node in the cluster on which NetBackup is installed. Refer to the clustering vendor’s documentation for information on how to migrate to another node. Unless otherwise noted, configure NetBackup to use the virtual host names of master servers and media servers in the cluster. For complete information on to how to configure an add-on product to fail over, see the NetBackup Clustered Master Server Administrator's Guide . Clustered environments For initial NetBackup server configuration, Veritas recommends that you launch the NetBackup Administration Console and click the Getting Started icon. A series of wizards guide you through the following configuration procedures: Configure Storage Devices See “About the Device Configuration Wizard” on page 121. Configure Volumes See “About the Volume Configuration Wizard” on page 123. Configure the Catalog Backup See “About the Catalog Backup Wizard” on page 124. Create a Backup Policy See “About the Backup Policy Configuration Wizard” on page 125.

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture