Check that the Endpoint OSNAP is ON Invoke the Line command icon L or Line

Check that the endpoint osnap is on invoke the line

This preview shows page 2 - 5 out of 11 pages.

Insure you are on the RSA layer.Check that the Endpoint OSNAP is ON.Invoke the Line command (icon, “L”, or “Line.”Select one RSA endpoint then select the other RSA endpoint and Enter.Enter again to re-invoke the Line command and repeat to close all RSA lines.e.Offset all RSA ends 1,000 feet from the runway end.f.Erase or delete original RSA end lines.g.Extend or Stretch RSA sides to new RSA end lines.h.Label the RSA on the RSA layer. Text height 75. See graphic below for label location.7.For both runways, create a runway obstacle free zone (ROFZ) with the dimensions for RDC D-IV with visibility minimums lower than ¾ mile (ref AC 150/5300-13A, pp. 271/283. See Addendum belowa.400 feet wide (200’ from the either side of the centerline), extending 200’ feet beyondeach end of the runway.b.Use same procedures as above for RSA.c.Label the ROFZ on the ROFZ layer. Text height 75. . 8. Trim the intersection. 9. Dimension the (1) runway, (2) ROFZ, and (3) RSA width on the runway 9 approach end area. See example below. a. Create a new DIMENSIONS layer: color = white, continuous, default all other parameters. 05b49154ffdf7d4a4b7ba9a498a832ef09d0248d.docx © Dr. John Cain 10/29/2016 17:42 a10/p10 2
Image of page 2
10. Select Dimension//Aligned . 11. Dimension the runway width first by following the command line prompts. a. After dimensioning the runway width, open Dimension Properties by double clicking the dimension just created. Set the properties as follows: Lines & Arrows Arrow size 30 Ext line offset 10 Text Text height 50 Text offset 5 Primary Units Dimension suffix ‘ (apostrophe) Precision 0 (not 0.000) b. Match Properties with all present and future dimensions. 05b49154ffdf7d4a4b7ba9a498a832ef09d0248d.docx © Dr. John Cain 10/29/2016 17:42 a10/p10 3
Image of page 3
12. Select Dimension//Aligned again and dimension the (1) ROFZ width and the (2) RSA width. 13. Dimension the (1) runway end to ROFZ end (200’) as follows: a. Insure Endpoint and Perpendicular OSNAPs are turned on by right clicking OSNAP button and selecting Endpoint and Perpendicular.
Image of page 4
Image of page 5

You've reached the end of your free preview.

Want to read all 11 pages?

  • Summer '19
  • Runway, runway safety area, Dr. John Cain

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture