B define the level of severity for messages sent to

This preview shows page 47 - 49 out of 66 pages.

We have textbook solutions for you!
The document you are viewing contains questions related to this textbook.
Guide to UNIX Using Linux
The document you are viewing contains questions related to this textbook.
Chapter 1 / Exercise 23
Guide to UNIX Using Linux
Palmer
Expert Verified
b. Define the level of severity for messages sent to the syslog server. To configure the severity levels, use either the keyword or the severity level number (0–7).
c. Use the logging trap command to set the severity level for R1.
d. What is the problem with setting the level of severity too high or too low?
e. If the command logging trap critical were issued, which severity levels of messages would be logged?
Step 4: Display the current status of logging for R1. a. Use the show logging command to see the type and level of logging enabled.
We have textbook solutions for you!
The document you are viewing contains questions related to this textbook.
Guide to UNIX Using Linux
The document you are viewing contains questions related to this textbook.
Chapter 1 / Exercise 23
Guide to UNIX Using Linux
Palmer
Expert Verified
0 flushes, 0 overruns, xml disabled, filtering disabled) No Active Message Discriminator. No Inactive Message Discriminator. Console logging: level debugging, 271 messages logged, xml disabled, filtering disabled Monitor logging: level debugging, 0 messages logged, xml disabled, filtering disabled Buffer logging: disabled, xml disabled, filtering disabled Logging Exception size (4096 bytes) Count and timestamp logging messages: disabled Persistent logging: disabled No active filter modules. ESM: 0 messages dropped Trap logging: level warnings, 0 message lines logged Logging to 192.168.1.3 (udp port 514, audit disabled, authentication disabled, encryption disabled, link up), 0 message lines logged, 0 message lines rate-limited, 0 message lines dropped-by-MD, xml disabled, sequence number disabled filtering disabled b. At what level is console logging enabled? c. At what level is trap logging enabled? d. What is the IP address of the syslog server? e. What port is syslog using? Step 5: (Optional) Use CCP to configure R1 to log messages to the syslog server. You can also use CCP to configure the router for syslog support. If you previously configured R1 for syslog and trap levels, you can skip this step. If you used Cisco IOS commands in Step 4 to configure R1 syslog and trap levels you can still perform this step but you need to issue the following commands first on the router: R1(config)# no logging 192.168.1.3 R1(config)# no logging trap warnings a. Open CCP and discovery R1 by entering the R1 IP address 192.168.1.1 in the Address field. Use admin for the username and cisco12345 for the password.

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture