Cisco 642 832 Practice Exam Pass Any Exam Any Time wwwactualtestscom 150

Cisco 642 832 practice exam pass any exam any time

This preview shows page 150 - 153 out of 323 pages.

Cisco 642-832: Practice Exam "Pass Any Exam. Any Time." - 150
Image of page 150
ActualTests.com B. The two hosts should be in the same VLAN in order to ping successfully. C. A Layer 3 device is a must in order for the ping command to be successful. D. The ping command will be successful without any further configuration changes. Answer: D Explanation: Normally, to transport packets between VLANs, you must use a Layer 3 device. However, in this case the "switchport mode access" command has been used for these ports so the VLAN information will be sent along untagged. Devices that are in different VLANs can ping each other as long as they are in the same subnet when the VLAN information is untagged. Section 23: Troubleshoot issues related to ACLs used to secure access to Cisco routers (2 Questions) QUESTION NO: 157 The following "show" command was issued on R1: Study the exhibit carefully. What will happen to traffic within VLAN 14 with a source address of 172.16.10.5? A. The traffic will be dropped. B. The traffic will be forwarded to the router processor for further processing. C. The traffic will be forwarded without further processing. D. The traffic will be forwarded to the TCAM for further processing. E. None of the other alternatives apply Answer: A Cisco 642-832: Practice Exam "Pass Any Exam. Any Time." - 151
Image of page 151
ActualTests.com Explanation: VLAN maps, also known as VLAN ACLs or VACLs, can filter all traffic traversing a switch. VLAN maps can be configured on the switch to filter all packets that are routed into or out of a VLAN, or are bridged within a VLAN. VLAN maps are used strictly for security packet filtering. Unlike router ACLs, VLAN maps are not defined by direction (input or output). To create a VLAN map and apply it to one or more VLANs, perform these steps: Create the standard or extended IP ACLs or named MAC extended ACLs to be applied to the VLAN. This access-list will select the traffic that will be either forwarded or dropped by the access-map. Only traffic matching the 'permit' condition in an access-list will be passed to the access-map for further processing. Enter the vlan access-map access-map-name [ sequence ] global configuration command to create a VLAN ACL map entry. Each access-map can have multiple entries. The order of these entries is determined by the sequence . If no sequence number is entered, access- map entries are added with sequence numbers in increments of 10. In access map configuration mode, optionally enter an action forward or action drop . The default is to forward traffic. Also enter the match command to specify an IP packet or a non-IP packet (with only a known MAC address), and to match the packet against one or more ACLs (standard or extended). Use the vlan filter access-map-name vlan-list vlan-list global configuration command to apply a VLAN map to one or more VLANs. A single access-map can be used on multiple VLANs.
Image of page 152
Image of page 153

You've reached the end of your free preview.

Want to read all 323 pages?

  • Fall '19
  • Open Shortest Path First

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture