The standard Ethernet frame length should not be less than 64 bytes Which of

The standard ethernet frame length should not be less

This preview shows page 2 - 4 out of 7 pages.

5.The standard Ethernet frame length should not be less than 64 bytes.Which of the following factors cause this limitation? (Multiple Choice)A. Minimum transmission distanceB. Maximum transmission distanceC. Working mechanism of conflict detectionD. MAC addressAnswer: BC2 / 7
Background image
6.The device IP addresses of the gateway NE and non-gateway NEs must be set inthe same network segment.7.Which of the following are the service board types of MSTP devices? (MultipleChoice)8.When the LCAS function is used, which of the following overhead bytes are used totransmit control information? (Multiple Choice)9.Which of the following are the electrical-layer overheads of OTN? (Multiple Choice)A. OPUkB. ODUkC. OChD. OTUkAnswer: ABD10.The working mode of a port determines the flow control mode of the port.When the working mode is 100 Mbit/s full duplex, which of the following flow controlmodes can be used?3 / 7
Background image
Image of page 4

You've reached the end of your free preview.

Want to read all 7 pages?

  • Winter '18
  • MAC address, Synchronous optical networking, Multiplexing, Wavelength-division multiplexing, H31-311 Dumps, HCIA-Transmission, H31-311, H31-311-ENU

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture