Tips for the Solidworks portion Creating the motion Add a rotary motor Your

Tips for the solidworks portion creating the motion

This preview shows page 6 - 9 out of 9 pages.

Tips for the Solidworks portion Creating the motion – Add a rotary motor Your Motion profile should be Segments and have the rotational velocity profile on the following slide Drag the time diamond so that the simulation lasts for 10 seconds
Image of page 6
Use a rotational velocity distribution that rises from 0 to 120 deg/s (20 RPM) over 2 seconds, then remains constant at 120 deg/s. 0 2 4 6 8 10 12 0 20 40 60 80 100 120 140 Rotational Velocity Time (s) Rotational Velocity (deg/s)
Image of page 7
Tips for the Solidworks portion Creating the motion – Make sure Solidworks Motion is enabled Select Motion Analysis Check the motion by pressing the calculate button (to the right of Motion Analysis)
Image of page 8
Tips for the Solidworks portion Analyzing the motion – Insert a plot for the Linear Displacement, Y component, between the top of the Table and bottom of the Base. If you reverse them, the plot will be upside-down. Do the same for Velocity and Acceleration. Finally, right-click on each plot and export data to a spreadsheet. From there you can copy it into the spreadsheet with the calculations.
Image of page 9

You've reached the end of your free preview.

Want to read all 9 pages?

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture