CVEN 4002 ULS SLS Foundation design Lecture 3 2018.pdf

Uls design see file cross section designxls from

This preview shows page 63 - 75 out of 75 pages.

????? ?????
Image of page 63

Subscribe to view the full document.

ULS Design: See file “ Cross Section Design.xls From chart or spreadsheet estimate required reinforcement area. Select bar diameter and spacing for top and bottom reinforcement Find NA depth and check ULS bending capacity Use file: RC design functions5.xlsb Umom input Umom out
Image of page 64
ULS Design: See file “ RC design functions6.xlsb Umom input:
Image of page 65

Subscribe to view the full document.

ULS Design: See file “ RC design functions6.xlsb Umom out: Check first spreadsheet: ‘Content’
Image of page 66
SLS Design: See file “ Cross Section Design.xls Check SLS stresses find depth of NA and compression face strain; check resultant force and moment: Use file: RC design functions5.xlsb Estress input Estress out (Similar to Umom)
Image of page 67

Subscribe to view the full document.

SLS Design: See file “ Cross Section Design.xls Check SLS stresses find reinforcement stresses and check against allowable stress for DL+LL and DL only:
Image of page 68
Check shear capacity and provide shear reinforcement as required (See file “ Cross Section Design.xls ”) 1 metre width design ???? ?????
Image of page 69

Subscribe to view the full document.

Minimum shear reinforcement area (See file “ Cross Section Design.xls ”)
Image of page 70