Item description syntax vcsu a update i ip u user p

This preview shows page 15 - 17 out of 31 pages.

ItemDescriptionSyntaxvcsu -a update -i <IP> -u <USER> -p <PWD> -l <FILE> [-f <FORCE>] -vcu<VCM USER> -vcp <VCM PASS> [-q] [-oe <ORDER>] [-of <ORDER>] [-we<MINUTES>] [-wf <MINUTES>] [-cp <CONFIG PASS>]Parameters:IPIPv4 or IPv6 address of the active OA in the enclosure*USERName of the OA user with privileges to access all enclosure interconnect bays. Minimumlength is 1 character. Maximum length is 40 characters.**PWDPassword of the OA user. Minimum length is 3 characters. Maximum length is 40characters.**FILEFull path to the Virtual Connect package on the local computer or supported remote serverFORCEOptional. Comma-separated list of force operations under certain conditions:version—Allows an update of the same firmware versionhealth—Allows an update on a module with failed or degraded healthVCM USERName of the Virtual Connect user with Domain privileges. This command is required if anenclosure is in a Virtual Connect domain. Minimum length is 1 character. Maximum length is31 characters.VCM PASSPassword for the Virtual Connect user. Minimum length is 3 characters. Maximum length is 31characters.-qOptional. Specifies that the firmware update does not prompt for confirmation before
Commands 16ItemDescriptionupdating, and uses the default answer for the confirmation (YES).-oeOptional. Specifies VC-Enet module activation order. The following activation order methodsare supported:parallel—All modules are activated at the same time.odd-even—(Default) The backup VC module is activated first. A force failover to thebackup module occurs, and then the primary module is activated. The modules in oddbays are activated, and then modules in even bays are activated.serial—The backup VC module is activated first. A force failover to the backup moduleoccurs, and then the primary module is activated. A checkpoint is completed between theprimary and standby module. Then the remaining modules are activated one at a time,starting with the lowest numbered bay.manual—Modules are updated but not activated. Use the VC GUI or the OA GUI toactivate (reboot) modules.-ofOptional. Specifies VC-FC module activation order. The following activation order methodsare supported:parallel—All modules are activated at the same time.odd-even—All modules in odd-numbered bays are activated first, and then modules ineven-numbered bays are activated.serial—(Default) Modules are activated one at a time, starting with the lowestnumbered bay.manual—Modules are updated but not activated. Use the OA GUI to activate (reboot)modules.-weOptional. Specifies the amount of time, in minutes, to wait between activating or rebootingVC-Enet modules. This command is required for some MPIO/teaming software on the serverblades in the enclosure. The default is 0, or no delay. HP recommends a minimum of 5minutes.-wfOptional. Specifies the amount of time, in minutes, to wait between activating or rebootingVC-FC modules. This command is required for some MPIO/teaming software on the serverblades in the enclosure. The default is 0, or no delay. HP recommends a minimum of 5minutes.

Upload your study docs or become a

Course Hero member to access this document

Upload your study docs or become a

Course Hero member to access this document

End of preview. Want to read all 31 pages?

Upload your study docs or become a

Course Hero member to access this document

Term
Spring
Professor
N/A
Tags
IP address, administrator, VCSU

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture