6 Click Next The Assign Memory page appears 7 In the Startup memory text box

6 click next the assign memory page appears 7 in the

This preview shows page 4 - 8 out of 9 pages.

6. Click Next. The Assign Memory page appears. 7. In the Startup memory text box, type 32 and then click Next. The Configure Networking page appears. Note The memory amounts used in this exercise are intended for demonstration purposes only. They are insufficient to run virtual machines with Windows guest operating systems. Question 1 Why are you unable to connect this virtual machine to a network? There is not an operating system installed on the VM. No virtual network adapters available.
Image of page 4
MOAC 70-410 - Installing and Configuring Windows Server 2012 R2 Lab Manual 8. Click Next. The Connect Virtual Hard Disk page appears. 9. Click Next. The Installation Options page appears. 10. Click Next. The Completing the New Virtual Machine Wizard page appears. 11.Click Finish. The wizard creates the new virtual machine, and it appears in the Hyper-V Manager console.End of exercise. You can leave the windows open for the next exercise.Question 2Why would a virtual machine in this default configuration fail to boot if you were to start it?Because there is not an operating systemLab Challenge Creating a VM with Windows PowerShellOverviewTo complete this challenge, you must create a virtual machine using Windows PowerShell commands, as you would on a Server Core installation.Completion time10 minutesCreate a new Generation 2 Hyper-V virtual machine named Vmachine2, with a 127 GB virtual hard disk and 512 MB of startup memory using the same default settings as the oneyou created with the New Virtual Machine Wizard in Exercise 7.2.Write out the Windows PowerShell command(s) that will execute the required settings. Then, take a screen shot of the Hyper-V Manager console showing the two VMs you created, Vmachine1 and Vmachine2, by pressing Alt+Prt Scr, and then paste the resulting image into the Lab 7 worksheet file in the page provided by pressing Ctrl+V.
Image of page 5
MOAC 70-410 - Installing and Configuring Windows Server 2012 R2 Lab Manual End of exercise. You can leave the windows open for the next exercise. Exercise 7.3 Configuring Dynamic Memory Overview In this exercise, you configure your virtual machine to use Dynamic Memory, enabling it to assign itself additional memory as needed. Mindset How can you tell how much memory a virtual machine needs at any given time? Completion time 10 minutes 1. On the SERVERB computer, in the Hyper-V Manager console, select the Vmachine1 virtual machine you created previously and, in the right pane, click Settings. The Settings for Vmachine1 on SERVERB dialog box appears. 2. In the Hardware list, click the Memory icon. The Memory page appears (see Figure 7-2).
Image of page 6
MOAC 70-410 - Installing and Configuring Windows Server 2012 R2 Lab Manual Figure 7-2 The Memory page of the Settings dialog box 3. In the Startup RAM text box, type 256 .
Image of page 7
Image of page 8

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture