Joint reinforcement in CMU walls generally consists ofC) two parallel wires connected together by cross wires.In general terms, which of the following stones is considered most durable? Which of the following materials increases the mortar's compressive strength? The most commonly used mortar joint thickness is in.The nominal dimension of a masonry unit whose actual dimension equals 7-5/8 in. is Some architects and engineers prefer to specify low-lift grouting in masonry walls because The nominal length of a typical CMU is
B) 16 in.Which of the following CMU shapes has a U-shaped profile in its vertical cross section? A drip mechanism at the underside of a projecting horizontal surface counters the effect of A backup wall is required in a(n) The coping on a roof parapet is generally The mortar commonly recommended for use in masonry walls in seismic regions is The flexural tensile bond strength of a masonry wall is a function of A mortar-capturing device in a brick veneer assembly is used The bricks used in brick-faced concrete curtain wall panels are generally The minimum width of the air space generally used between a brick veneer and a wood stud backup wall is The glass fibers used in the GFRC skin are referred to as AR fibers. The term AR is an acronym for A bond beam in a masonry bearing wall building must be
The most commonly used exterior finish on tilt-up wall panels is In addition to water, a stucco base coat mix consists of The term kerf in stone cladding industry refers to In an adhered masonry veneer, masonry units are adhered to the backup surface using
You've reached the end of your free preview.
Want to read all 20 pages?
- Fall '19
- Nadia Blake