Time Channel_.i Channel_B
0.000 s 403.610 FV -4.990 0 Reverse l
499.025 us -122.446 mv -5.060 v .
499.025 us -122.446 mv -61.?64 mi Save I EXt' "'99
(a
Timehase Channel #1 Channel B Trigger
Scale I 1'30 USiIDiV Scale '5 WDW Scale '5 WDW Edge If _II B IExt
Time Channel_.i Channel_B
129.838 us 2.680V 1?.856 m'v'
199.805 US 9.183 ml! -1.224'|.I' .
.'-"|II.1T"5 us -2.6.'-"1 v -1.241 v 55"? I EXt' "'99
.r:
Timebase Channel .9. Channel B Trigger
Scale I5U USIDW Edge
X position I0 Level
IW'T Add| BIAI 8r8|
Time Channel Channel_B
.002 ms 122.413 m 3.141 m Reverse I
249.513 us 9.9951: 11.009 011 .
$52.43? us 9.324 v -3.130 mi Save I EXt' Tr'gger
a
Timebase Channel A Channel B Trigger
Scale IEDD USIDW Scale I5 WDW Scale 2 mWDiV Edge If '1: T B IExtI
X posi
Vangjeris Dhroso (Writer)
Rodney Barahona (Partner)
Capacitor and Inductor Analysis
Chapter 6
December 3, 2009
Lab Objective:
The objective of this lab was to work with capacitors and inductors. We were given three
circuits but only worked with two of the
Vangjeris Dhroso
Partner: Rodney Barahona
EEN2140 - Circuit Theory 2
4/26/10
Introduction:
The purpose of this lab was to solve for nodal voltages in an AC circuit and compare
calculated values with Multi-Sim values. We also had to solve for the AC rms me
Vangjeris Dhroso
Partner: Rodney Barahona
EEN2140 - Circuit Theory 2
4/12/10
Introduction:
The objective of this lab was to determine the real, reactive, and apparent power and the
power factor for a series R-C circuit, series R-L circuit, and series R-L-
Vangjeris Dhroso (Writer)
Rodney Barahona (Partner)
Additional Analysis Techniques
Chapter 5
November 19, 2009
Lab Objective
The objective of this lab is to perform current source transformations, by replacing
current sections with equivalent voltage sour
Vangjeris Dhroso
Partner: Rodney Barahona
EEN2140 - Circuit Theory 2
4/26/10
Introduction:
The objective of this lab was to plot the gain and phase response of an R-C low-pass
filter, determine the cutoff frequency of an R-C low-pass filter, and determine
Vangjeris Dhroso (Writer)
Rodney Barahona (Partner)
Additional Analysis Techniques
Chapter Five
November 12, 2009
Lab Objective:
The objective of this lab is to focus on applications of Linearity, Superposition, and
Thevenin's Theorem. In this lab we were
Vangjeris Dhroso
Partner: Rodney Barahona
EEN2140 - Circuit Theory 2
2/15/10
Introduction:
The purpose for this laboratory was to determine the phase relationship between the ac
voltage and current in an inductor. We were to also determined the inductive
Vangjeris Dhroso (Writer)
Rodney Barahona (Partner)
Continuing with Operational
Amplifiers
October 21, 2009
Lab Objective:
We had two circuits in this lab. For the first circuit we had to lay it out and test the
subtractor. The circuit is also known as a
Vangjeris Dhroso (Writer)
Rodney Barahona (Partner)
Basic Circuit Concepts with
Operational Amplifiers
October 21, 2009
Lab Objective:
The objective of this lab was to lay out three circuits on a breadboard using op amps. We
were to solve for desired meas
Vangjeris Dhroso
Partner: Rodney Barahona
EEN2140 - Circuit Theory 2
2/22/10
Introduction:
The purpose of this laboratory was to determine the phase relationship between the ac
voltage and current in a capacitor. We were to also determine the capacitive r
Vangjeris Dhroso
Rodney Barahona
Introduction to Physical and Simulation Circuit
Concepts
&
Continuation of Basic Circuit Concepts
September 24, 2009
Lab Objective:
For lab one, we had two objectives. First we had to lay out the circuits on a breadboard a
Vangjeris Dhroso
Partner: Rodney Barahona
EEN2140 - Circuit Theory 2
3/1/10
Introduction:
The objective of this lab was to measure the impedance of a series R-L circuit and the
phase between the ac voltage and current and compare the measured values with
Vangjeris Dhroso
Partner: Rodney Barahona
EEN2140 - Circuit Theory 2
2/10/10
Introduction:
In this lab we worked with transients in RLC circuits. We were to determine the step
response for the current in a series R-L-C circuit that is over damped and also
Vangjeris Dhroso
Partner: Rodney Barahona
EEN2140 - Circuit Theory 2
3/15/10
Introduction:
The objective of this lab was to measure period and frequency of an ac waveform,
measure amplitude and peak to peak voltage, measure instantaneous voltage, and
dete
Vangjeris Dhroso
Partner: Rodney Barahona
EEN2140 Circuit Theory
2/1/10
Introduction:
In this lab we had to perform two different experiments. Part A of the lab was to design
two circuits. One circuit had to light up one LED and the other circuit had to l