Lab 188.8.131.52 Use Network Inspector to Observe STP Behavior
The purpose of this lab is to observe STP behavior with the Network Inspector switch trace feature.
A new switched network has just been installed. The Spanning-Tree Protocol (ST
Lab 184.108.40.206 Introduction to Fluke Network Inspector
This lab is a tutorial demonstrating how to use the Network Inspector (NI) from Fluke Network to
discover and analyze network devices in a broadcast domain.
This lab will demonstrate the key pr
Lab 220.127.116.11 Introduction to Fluke Protocol Expert
This lab is a tutorial demonstrating how to use the Fluke Network OptiView Protocol Expert (PE) to
analyze network traffic. In this lab, students will see the key features of the tool so that the
Lab 18.104.22.168 Per-VLAN Spanning-Tree Load Balancing
The purpose of this lab is to modify the default behavior of spanning tree for VLAN load balancing
using Cisco IOS commands.
Two distribution layers and two access layer switches have be
Lab 22.214.171.124 Catalyst 2950T and 3550 Series VTP Domain and VLAN Trunking
Configure a VLAN trunk between two Cisco Catalyst WS-C2950T-24-EI switches and a Cisco
Catalyst WS-C3550-24-EMI switch in the command-line interface (CLI) mode.
Lab 126.96.36.199 Catalyst 2950T and 3550 Configuration and IOS Files
Upload and download configuration files and the IOS System Image files.
It is important to be familiar with the fundamental aspects of working with configuration files and
Lab 2.1.7 Catalyst 2950T and 3550 Series Static VLANS
Create and maintain VLANs on a Cisco Catalyst 2950T or 3550 series Ethernet switch using the
command-line interface (CLI) mode.
VLANs must logically segment a network by function, te
Lab 188.8.131.52 Spanning-Tree Protocol (STP) Default Behavior
The purpose of this lab is to observe the default behavior of STP.
Three switches have just been installed. The distribution layer switch is a Catalyst 3550 and the
Lab 184.108.40.206 Catalyst 2950T and 3550 Series Basic Setup
Configure a Cisco Catalyst 2950T or 3550 series Ethernet switch for the first time using
the command-line interface (CLI) mode. Basic first time tasks such as configuring a
switch name, pass
Lab 220.127.116.11 Catalyst 2950T and 3550 Series Password Recovery
Recover passwords while retaining configurations for the Cisco Catalyst 2950T and 3550 series of
Access to a network device may be denied because of an inco