CAEE 232 Solid Mechanics I Homework #10
Problem #1
Given that the diameter of the belt at C is 0.5 in
and is in single shear, determine the shear stress 10 k
acting in the bolt.
Z
3ft
Problem #2
A circular rod made of aluminum is 2.25 inches in diameter
CAEE 232 - Solid Mechanics I Homework #6
Problem #1
The bar ABCD shown in the sketch is made up of Steel (E=30*106psi). The lengths and cross
section areas are indicated in the sketch. It is desired to determine the reactions at A and D, as
well as the di
CAEE 232 Solid Mechanics I Homework #9
Problem #1
The aluminum post shown in the sketch is reinforced with a brass core. This assembly supports
an axial compressive load of P=9 kip, applied to the rigid cap. Determine the average normal
stress in the alum
CAEE 232 Solid Mechanics I Homework #8
Problem #1
A rigid plate of weight W is supported by three solid circular steel columns of diameter 250
mm each. The outer two columns are 2 m long while the inner column is 0.25 mm short. If
E55210 GPa and the allow
CAEE 232 Solid Mechanics I - Homework #7
Problem #1
n
The rigid horizontal bar shown in the enclosed sketch is xed to the top of three posts
made of steel A36 and 2014-T6 aluminum. The posts each have a length of 250 mm when no
load is applied to the bar,
HOMEWORK #4 - Due on Friday September 2, 2016
Problem #1
The bar shown below is axially loaded at B, C and D by the forces given in the sketch. It
is required to draw the Axial Force Diagram for the internal loading along the bar>
B C D
/
100k=80k 20k
41
CAAEE 232 - Solid Mechanics I Fall 201$
Homework 2 Review Moments of Inertia
Find the moments of inertia of the three sections listed below relative to the vertical and
horizontal axis passing through the centroid of each section.
Problem ] (for 30 points
CAEE 232 Solid Mechanics I Homework #5
Problem #1
The bar ABCD is axially loaded as indicated in the
sketch. The entire bar is made of steel with an
elastic modulus E of 30"103 ksi. Determine the
elongations of sections AB, BC, and CD and the
horizontal
CAAEE 232 - Solid Mechanics I Fall 201 5
Homework 1 Review Equilibrium & Centroids
Problem I
Determine the reactions for the beam loaded as
shown. Draw a do f b - , .
the beam. dr ree 0d)" diagram for
WM!
Problem 2
Draw a clear free body diagram and det
CAAEE 232 - Solid Mechanics 1 Fall 2016
Homework#3 Review Moments of Inertia I]
Find the moments of inertia of the three sections listed below relative to the vertical and
horizontal axis passing through the centroid of each section.
Problem 1(for 30 poin