Engineering Calculus deflection review
(a) Suppose L = 5 m, b = 1 m, E = 51010 N/m2, I = 810 5 m4, and P = 120 N. Plug
these values into the equation for deflection, then find the value for x that
(b) maximizes the deflection. Prove that your value for x

Engineering Calculus problem 1 review
Problem 1: Use the diff command in MATLAB to find the first and second derivative of
the following function with respect to t. Include both your results and your MATLAB
commands.
Problem 2: The graph below shows posit

Engineering Calculus graph results review
(a) Verify your results graphically by plotting the range vs. launch angle (using the values
given in part (b) and marking the maximum range using the Data Cursor Tool.
Launch angle should be on the x-axis and ran

Engineering Calculus exam 1 review
For each of these problems include both your MATLAB commands and
results. Be sure to include units in your answers!
Problem 1: The equations of motion for the x and y position of a projectile fired
at an initial velocity

Engineering calculus problem 5 review
Problem 5: In Lab 4, you determined the angular paths for the two-link robot arm
given starting coordinates of (6.5, 0), ending coordinates of (0, 2), links lengths of
4 and 3, and a final time of 10 seconds.
Th1_star

Engineering calculus problem review
For each of these problems include both your MATLAB commands and results. Be
sure to include units in your answers!
Problem 1: The equations of motion for the x and y position of a projectile fired at an
initial velocit

Engineering calculus underdamped review
Problem 3: In Models I, we graphed the equation for damped harmonic motion.
If the response is underdamped, the displacement of the mass can be modeled
mathematically as follows:
d: displacement of the mass in meter

Engineering Calculus submit code review
Uses the displacement measurements to estimate acceleration
Creates another set of t-values with a much finer increment than dt
Calculates displacement, actual velocity, and actual acceleration over this
second rang

Engineering Calculus quiz 2
Problem 1: Use the diff command in MATLAB to find the first and second derivative of
the following function with respect to t. Include both your results and your MATLAB
commands.
Problem 2: The graph below shows position measur

Engineering Calculus quiz 1 review
(a) Suppose L = 5 m, b = 1 m, E = 51010 N/m2, I = 810 5 m4, and P = 120 N.
Plug these values into the equation for deflection, then find the value for x
that
(b) maximizes the deflection. Prove that your value for x does