CPS 250 HW #1
Due: Sept. 14, 2015
1. Translate the following code into MIPS code.
A[i - 6] = A[i + 2] + 10;
i = i + 7;
A[3] = A[i - 1];
a) Assume A is an array of integers (each integer takes 4 bytes)
CPS 250 HW #1
Due: Sept. 14, 2015
1. Translate the following code into MIPS code.
A[i - 6] = A[i + 2] + 10;
i = i + 7;
A[3] = A[i - 1];
a) Assume A is an array of integers (each integer takes 4 bytes)
CPS 250 HW #1
Due: Sept. 14, 2015
1. Translate the following code into MIPS code.
A[i - 6] = A[i + 2] + 10;
i = i + 7;
A[3] = A[i - 1];
a) Assume A is an array of integers (each integer takes 4 bytes)
LAB Introduction to GNS3
PART1. GNS3 INSTALLATION & SETTINGS
In this first part of the lab, you learn how to install and tune GNS3. You will also learn how to use
the desktop to configure networks.
Ex
V;
\J', -4.- .9
.X R34 I
Thy/ST ane m (ea/L F
2: v: I K '&T 1 g} .4 . _
K7: R + 77 1-
mm; b w», A Vol/w 4W VA; 1.y91y3 /
* I 2 Vi + 2(1)}
-Ufzviu'fbifh5
Yacwad of 10 MA 5ng {J' '3 m , how Wm; Wis-Ala
Objective:
The purpose of the Parallel DC Circuits, Negative Voltages, Power and Multi-Meter use
was to introduce the concept of parallel circuits and compare that to the previous lab when we
were dea
Objective:
The purpose of this lab was to understand how the Oscilloscope works and how to
generate and read the function generator. At the conclusion of this exercise, our understanding of
how parall
Objective:
The purpose of this lab was to understand how the Oscilloscope works and how to
generate and read the function generator. At the conclusion of this exercise, our understanding of
how parall
Objective:
The purpose of this lab was to understand how components found in a household are
wired and how to get them all to complete the circuit and function properly.
Equipment Used:
Junction box
1
Objective:
The objective of this lab was to construct and analyze data obtained from a Series/Parallel
AC circuit. Analysis included calculations, MultiSim simulation, and oscilloscope readings.
Equip
Objective: The objective of this lab is to analyze and construct series AC circuits containing
high pass and low pass filters through the use of simulators and Bode plots.
Equipment Used:
Function Ge
ECT 110L
Fall 2012
Series DC Circuits
and Multi-Meter Use
By:
Ryan Berry
Submitted on:
September 4, 2012
Prepared for:
Prof. Van Donkelaar
Objective:
The purpose of the DC series circuits lab was to i
Objective:
The objective of this lab was to understand how Transformers work in a circuit when
powered by a DC power supply.
Equipment Used:
Multi-meter
Power Source
840 pt. Breadboard
Resistors
Elect
Objective:
The objective of this lab was to construct the given circuit and simulate maximum power
transfer and understand the concept of Power Factor Correction.
Equipment Used:
Multi-Sim
Calculator