the circuit below:
all the circuit nodes and write the KCL equation
The maximum power transfer theorem assumes that RTH is fixed, and that load resistor RL can be
adjusted to maximize its power dissipation. For parts (a) through (c), we will assume th
Pinlem 8-16 glultbi.
Initially switch A is open such that the steady-state assumption applies. At time t = 0 s the switch
begins to close and reopen every 100 ms.
3. Find the voltage V(;[0') at time t = 0 s (the instant before switch A closes for th
For an idealop amp,the openloopgainis assumedto equalinfinity. In an actualop amp,the open
loop gainis largebut not infinite,which meansthat the closedloopgainof a "realworld" circuit
will not be the sameasthe idealvalue,resultingin a phenomen
Consider the following ideal op amp circuit. Let R1 = 2><R2 = 1 k9.
a. Derive an expression for the voltage Va in terms of the input voltages V1 and V2
and resistor RL.
b. Derive an expression for IL in terms of input voltages V1 and
EECE 112 Homework Format
Because of the large number of problems that must be graded every week, a specific
homework format is required so that the EECE 112 graders can evaluate each assignment
as quickly as possible.
Please follow this format for all hom
Department of Electrical Engineering and Computer Science
Featheringill Hall 247
Office hours: See Instructors/TAs section on
Instructions for Installing and Using Mathematica
Note: If you already have a version of Mathematica on your laptop, and it is working properly,
there is no need to install the student version for this class.
If you have Mathematica installed on your lapt
-', \r/'*'r- =Vc
It is often desirable to reset an inverting integrator circuit to a zero initial condition, as shown
above. A switch is used to zero out the voltage across the capacitor and force Vour = 0.