1.What are two features of a link-state routing protocol? (Choose two.)
Routers send triggered updates in response to a change.*
Routers create a topology of the network by using information from other routers. *
2.Fill in the blank.
In IPv6, all routes a
Lab - Mapping the Internet
Part 1: Test Network Connectivity Using Ping
Part 2: Trace a Route to a Remote Server Using Windows Tracert
Part 3: Trace a Route to a Remote Server Using Web-Based and Software Tools
Part 4: Compare Traceroute Result
1)Refer to the exhibit. What should be done to allow PC-A to receive an IPv6 address from the DHCPv6
Add the ipv6 dhcp relay command to interface Fa0/0.*
2) What is the reason why the DHCPREQUEST message is sent as a broadcast during the DHCPv4
1 )A network administrator needs to configure a standard ACL so that only the workstation of the administrator with
the IP address 192.168.15.23 can access the virtual terminal of the main router. Which two configuration commands
can achieve the task? (Ch
1. Which three statements accurately describe VLAN types? (Choose three).
After the initial boot of an unconfigured switch, all ports are members of the default
A management VLAN is any VLAN that is configured to access management features of
1) What are two advantages of static routing over dynamic routing? (Choose two.)
Static routing is more secure because it does not advertise over the network.*
Static routing uses fewer router resources than dynamic routing.*
2)Refer to the exhibit. Which
1 Which OSPF component is identical in all routers in an OSPF area after convergence?
2 Which three statements describe features of the OSPF topology table? (Choose three.)
When converged, all routers in an area have identical topolog
1. Refer to the exhibit. What will the router do with a packet that has a destination IP address of
Drop the packet.
Send the packet out the GigabitEthernet0/1 interface.
Send the packet out the Serial0/0/0 interface.
Send the packet out t
1.Refer to the exhibit. The switch does the routing for the hosts that connect to VLAN 5. If the PC accesses a web server
from the Internet, at what point will a VLAN number be added to the frame?
No VLAN number is added to the frame in this design.
1. Which interface is the default location that would contain the IP address used to manage a 24-port Ethernet switch?
interface connected to the default gateway
2. Which three statements are true about using full-duplex Fast
Refer to the exhibit. Consider that the main power has just been restored. PC1 asks the DHCP server for IPv4 addressing.
The DHCP server sends it an IPv4 address. While PC2 is still booting up, PC3 issues a broadcast IPv4 DHCP request. To
which port wil
Lab - Researching IT and Networking Job Opportunities
Part 1: Research Job Opportunities
Identify the current networking jobs that are in demand.
Explain the value of Cisco certifications in the job market.
Part 2: Reflect on Research