2-D MODELING OF A PROTON EXCHANGE MEMBRANE FUEL CELL
A THESIS SUBMITTED TO
THE GRADUATE SCHOOL OF NATURAL AND APPLIED SCIENCES
OF
MIDDLE EAST TECHNICAL UNIVERSITY
BY
ERTAN AGAR
IN PARTIAL FULFILLMENT OF THE REQUIREMENTS
FOR
THE DEGREE OF MASTER OF SCIENCE
ME 410 MECHANICAL ENGINEERING SYSTEMS LABORATORY
MASS & ENERGY BALANCES IN
PSYCHROMETRIC PROCESSES
EXPERIMENT 3
1. OBJECTIVE
The objective of this experiment is to observe four basic psychrometric processes which
are heating, cooling, humidification and d
ME-410
MECHANICAL ENGINEERING SYSTEMS LABORATORY
EXPERIMENT-6 CHARACTERISTICS OF AN AIRFOIL
OBJECT
The aim of this experiment is to obtain the pressure distribution around an airfoil, and
to determine the lift, drag and pitching moment variations with dif
ME 410
MECHANICAL ENGINEERING SYSTEMS LABORATORY
PERFORMANCE CHARACTERISTICS OF AN
INTERNAL COMBUSTION ENGINE
Experiment No. : 4 SPRING 2012 V2
1. OBJECT
The object of this test is to show the variation of basic engine characteristics under different
engi
E 410
MECHANICAL ENGINEERING SYSTEMS LABORATORY
EXPERIMENT 5
STRESS ANALYSIS BY USING STRAIN GAGES
OBJECTIVE
The objective of this experiment is to become familiar with the electric
resistance strain gage techniques and utilize such gages for the
determin
ME 410 Mechanical Engineering
Systems Laboratory
Laboratory Lecture 1
GEOMETRIC TOLERANCING & SOURCES OF ERRORS
Geometric dimensioning and tolerancing (GD&T) is a symbolic
language used on engineering drawings and computer generated
three-dimensional soli
ME 410
MECHANICAL ENGINEERING SYSTEMS LABORATORY
EXPERIMENT # 1
STRAIGHTNESS AND FLATNESS MEASUREMENTS
ON A SURFACE TABLE
OBJECT :
To measure the straightness of a surface table along a finite number of lines
(generators): then to determine the flatness o
Middle East Technical University
Mechanical Engineering Department
ME 410 Mechanical Engineering Systems Laboratory
Spring 2012
Laboratory Maps
Exp. 1
Exp. 2
Exp. 3
Exp. 4
Exp. 5
Exp. 6
Measurement of Geometrical
Errors in ManufacturingFlatness Measuremen