Project Part 1 Design an IP addressing scheme
Based on the IP requirements for 8 subnets and 30 hosts, complete the table below to
determine the IP address ranges for the 8 subnets required.
IP Subnet Address Ranges
Subnet mask: 255.
Your current company network includes 14 hubs (a mix of 8 and 12 ports),
2 routers, and 3 servers to support 10 departments. Management has asked you
to recommend upgrading the hubs to switches. Which manufacturer and model
switch would you recommend?
Why would you implement half-duplex on an Ethernet network ?
You would want to use half duplex Ethernet because half duplex Ethernet uses
the CSMA/CD protocol, this protocol helps prevent collisions from happening during a
network transmission. Half du
1. Review a Cisco 2950 Catalyst Switch found at:
n0900aecd800b1dbd.html. After you have reviewed the components of a
catalyst switch, write a half-page summary describing four switch
Explain and provide an example of how to define a static route.
Explain when static routes would be used.
A static route is a predetermined and hard coded path that data is told to
travel through a network. You would use a static route on a network in
Describe the purpose of a serial interface on a router.
The serial interface of a router is the a communications interface device
that is used when making a connection between routers and switches
together on a local area network (LAN) with a higher sp
The Cisco 2611 router has many different features that can suite your everyday routing
The CPU of the router executes instructions coded into the operating system and
all the sub systems to perform the basic needs that are needed to handle the task
You want to divide a class C network into 12 subnets. Which subnet mask
will you use to get the most hosts on each network? How many hosts will be on
each subnet? Explain your answer.
By using the subnet mask 255.255.255.240 this allows me to get close
Identify the three IP address classes, the default subnet mask used with
each, and the number of hosts for each.
The three different IP address classes are Class A, Class B, and Class C. the
subnet mask for Class A is 255.0.0.0. The subnet mask for Cla
Detail the function of a router and how its used on a network
A router acts as a conduit for a network to connect to the internet. A router
commonly has a built in switch to allow multiple hard lines to connect directly to
it. Routers give off a wirele
Describe the four-step process to locate and load the IOS.
The steps needed to locate and load the IOS for a cisco router is to use
To enter ROMMON mode use ctrl+C which the router begins to start up.
2. In ROMMON mode use the rommon> c