ECE 5211 Analog IC Design
Homework # 2
Note:
1) Some of the problems use Figures in text part of the book, whereas some of them use
the Figures in the Problem Section. In the later case, there is usually a letter P before the
figure number.
2) You are sup
1. Design a commonsource amplier with a resistive load based on the schematic shown below
with the following design specications:
VDD21
Transistor M1 is in saturation
The minimum possible output voltage to keep M1 in saturation is 0.2V
Total power con
EECE488 Analog CMOS Integrated Circuit Design
Assignment 4
Due: Thursday March 18th, 2010 at 9:30am
1. Assuming all the transistors in the following symmetric circuits are in saturation, 0 and
= 0, calculate the small-signal differential voltage gain of
EECE488 Analog CMOS Integrated Circuit Design
Assignment 3
Due: Thursday March 4th, 2010 at 9:30am
In this assignment, unless otherwise stated, please use the following device parameters:
= = 0, VTH0(NMOS)= 0.5V, VTH0(PMOS)= -0.6V, nCox = 200 A/V2, pCox=
EECE488 Analog CMOS Integrated Circuit Design
Assignment 1
Due: Tuesday February 12th, 2013 at 9:30am
1. Based on Problem 2.16 of the Razavis book:
a) Consider the structure shown in the following figure. Determine ID as a function of VGS
and VDS and prov
EECE488 Analog CMOS Integrated Circuit Design
Assignment 3
Due: Thursday March 21, 2013 at 9:30am
1. In the following circuit assume transistors M1 and M2, and transistors M3 and M4 are identical
and = 0: and 0:
i) Find the expression for the small-signal