Week 5 Lab
My first step was to determine the status of the network. I did this by using the show ip protocol and show ip route
commands on all three networks. I then Verified that all interfaces are accessible throughout the network. I
Week 3 Lab Assignement
On this assignment we configured a RIP network. Router 1 is the hub router, which is our
corporate site in Washington, DC. Then we have two remote office routers (Router 2 which is
named [Minot] and
Cisco Networking Academy
Lab: Configuring Switch Security Features
1. Issue the show vlan command on S1. What is the status of VLAN 99? active
2. Issue the show ip interface brief command on S1. What is the status and protocol
Re-issue the show ip route and show ipv6 ospf neighbor commands on R1 and R3,
Contemporary Fine Arts
Analyze the cultural changes that took place during the 20th century as shown in the
aesthetics of that period.
1. Warhol, A. (1975). The philosophy of Andy Warhol: From A to B
1. You will use a numbered extended ACL on R1. What are the ranges for extended
ACLs? 100-199 and 2000-2699
2. What does the 80 signify in the com
Cisco Networking Academy
Lab Configuring Basic Router Settings with IOS CLI
1. Besides setting a minimum length, list other ways to strengthen passwords. Use both numbers
and letters varying between upper and lowercase.
2. For the exec-timeo
1. What is the translation of the Inside local host address? 192.168.1.20 =
2. The Inside global address is assigned by? By the gateway
Packet Tracer Lab 184.108.40.206 Investigating Directly Connected Routes
Part 1 Step 2
b. C 172.31.20.0/23 is directly connected, GigabitEthernet0/0
C 172.31.22.0/23 is directly connected, GigabitEthernet0/1
C 220.127.116.11/30 is directly connecte
=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2015.05.22 11:01:47 =~=~=~=~=~=~=~=~=~=~=~=
Current configuration : 1306 bytes
! Last configuration change at 15:06:55 UTC Fri May 22 2015
service timestamps debug datetime
Zephan Gilani, Ray Tajeda & Matt Tullo.
The Switch does not want to accept the
username or neither the password ever though we
put it right and the command it still does not work!
We encounter a problem with the default gateway
because of the sub
Week 7 Lab Assisgnment
This week we worked on configuring OSPF on three routers Chicago, Indianapolis and Columbus.
Learned how to verify OSPF operation and how to test and verify configurations.
Week 6 Lab Assignment
This week we had to design a new IP Addressing Scheme and interface for each network. Then we had to implement the
new IP address on router 1, 2 and 3. We then had to configure EIGRP on all three routers and Miigra
Basically, this week we configured routers for New York and Tokyo and London. To start, I had to
determine the status of all three routers. We used the ping tests to determine the connectivity status on
Newyork, Tokyo and London and their interfaces. I th
I have attached a copy of the transcript so that you can see the date it was completed. First I ran a ping test on the
following network 18.104.22.168. I then enter configuration mode, and added the IP address I then configured a static route
pointing to the I
Week 4 Lab
First you have to configure all three routers with an IP address and host names.
Then you have to turn on RIP by using enable RIP and then you have to debugging on all three
routers using the command debug RIP. This allows th