FLUID MECHANICS
- a science that deals with the study of fluid either at
rest or in motion
FLUIDS
- substance that has no permanent shape , have
always the tendency to flow
Branches of Fluid Mechanics:
1. HYDROSTATICS
- deals with the study of fluid at re
1
Unit I
INTRODUCTION TO ELECTRONICS
The label electrical may be attached to any instrument, appliance, machine, or interconnected devices in which
electricity is necessary for its operation. They contain resistors, capacitors, and inductors.
http:/www.as
Hand-Outs in Diesel Engine Power Plant
SOURCE: http:/fetweb.ju.edu.jo/staff/me/jyamin/Power%20Plant/Diesel%20Power%20Plant.pdf
FOR STUDENTS IN POWER PLANT ENGINEERING
Compiled By: Prof. Rogelio A. Antenor, MSME, MEM
Diesel Electric Power Plants
23.1. Intr
HAND-OUTS IN VARIABLE LOAD
PROBLEM
FOR STUDENTS IN POWER PLANT ENGINEERING
Compiled By: Prof. Rogelio A. Antenor, MSME, MEM
Load Curves and Selection of Generating Units
Because demand is continuously varying and power cannot be stored, the power output o
What are the three types of Geography?
Geography is the science that studies the lands, the features, the inhabitants, and the
phenomena of the Earth. It is commonly divided into three branches:
I.
Physical geography: nature and the effects it has on peop
The History of Atomic
Structure
AKA: The old, dead guy parade!
CA State Standards: 1h and 1i
Democritus (460 - 370 BC)
Was the first person to come
up with the idea of atom
Believed that all matter was
composed of indivisible
particles he called ATOMS
Was
VVQWZ. g
_ 6.79 For the frame and loading shown, determine the components of
_ all forces acting on member ABC. W _ _-_ ._. _.
WE
ngxaq: A; +/8 EN =&
f-lB/V gs/8 M- 4
1327/34.: =0: ,
(/8 MXW)". 935x) =
- 4049/ 53
SECTION 1 DESIGN FOR SIMPLE STRESSES
TENSION, COMPRESSION, SHEAR
DESIGN PROBLEMS
1.
The link shown, made of AISI C1045 steel, as rolled, is subjected to a tensile load
of 8000 lb. Let h = 1.5b . If the load is repeated but not reversed, determine the
dime
SECTION 7 SHAFT DESIGN
471.
A short stub shaft, made of SAE 1035, as rolled, receivers 30 hp at 300 rpm via a
12-in. spur gear, the power being delivered to another shaft through a flexible
coupling. The gear is keyed (profile keyway) midway between the b
SECTION 8 KEYS AND COUPLINGS
FLAT AND SQUARE KEYS
DESIGN PROBLEMS
521.
A 2-in. shaft, of cold-drawn AISI 1137, has a pulley keyed to it. (a) Compute the length of square
key and the length of flat key such that a key made of cold-drawn C1020 has the same
12
Unit II
ELECTRONICS IN A VACUUM
WILLIAM CROOKES MAGICAL TUBES
In 1880, three years before Edison invented the incandescent lamp, Crookes watched a strange
occurrence while air was gradually being pumped out from a long glass tube. Electricity was being
