Circuit requires 5V voltage that has been regulated, in this project the light used is a LED light. if you want to use the lamp 220V or higher voltage you will need the Relay Board as a liaison microcontroller with lights.
To Relay Board I will publish a
Flashing LED ALGORITHM
2. Turn ON LED.
3. Turn OFF LED.
4. GO TO 2.
We now want to flash a LED. It works by turning ON a LED & then turning it OFF & then looping back to START. However the operating speed of microcontroller is very high so
8-bit CPU,Reg A,Reg B
15-bit PC and Data Pointer(DPTR)
Internal ROM and EPROM (8751)
Internal RAM of 256 bytes
Architecture of 8051:
Registers in 8051
* indicates tha
The 8051 Microcontroller
The microcontroller incorporates all the features that are found in microprocessor.
The microcontroller has built in ROM, RAM, Input Output ports, Serial Port,
timers, interrupts and clock circuit. A mic