Homework: Introduction to Java
This document defines homework assignments from the "Java Basics" Course @ Software University. Please submit
as homework a single zip / rar / 7z archive holding the sol
1 )
2)
Latency is delay time that response of processor for interrupt. It refers to the number of
clock cycles .
3)
CMP R0, R1
BGT median1
CMP R1, R0
BGT median2
CMP R2, R1
BGT median3
.median1:
CMP R
1.1
a)
b)
c)
d)
e)
f)
Voltage is current multiple resistance.
Current is voltage divided resistance.
Power is rate of the doing work.
Energy is property needed to moving the object.
KCL is the sum of
1.1
a)
b)
c)
d)
e)
f)
Voltage is current multiple resistance.
Current is voltage divided resistance.
Power is rate of the doing work.
Energy is property needed to moving the object.
KCL is the sum of
1.1
a)
b)
c)
d)
e)
f)
Voltage is current multiple resistance.
Current is voltage divided resistance.
Power is rate of the doing work.
Energy is property needed to moving the object.
KCL is the sum of
1.1
a)
b)
c)
d)
e)
f)
Voltage is current multiple resistance.
Current is voltage divided resistance.
Power is rate of the doing work.
Energy is property needed to moving the object.
KCL is the sum of
EE 273 - Homework #5 - Getem all!
Due: 18 / 11
This homework should have all the information that you would need to solve all the questions.
Check Appendix section for the supplementary information. G
EE 273 - Homework #2
Due: 4/11
Make all your circuit diagram drawings either in Xilinx ISE or h
ttp:/www.digikey.com/schemeit
Make sure to add the ports as well. Then paste your screenshots.
1. Draw
EE 273 - Homework #3 - Boolean Theorems and Gate-Level Minimization
Due: 11 / 11
1. Simplify the following expression using the B
oolean theorems.
X =
2. A room has four doors and four light switches
EE 273 - Homework #5 - Combinational Logic
Due: 26 / 11
1. Add the following in binary. Check your results by doing the addition in decimal.
a. 1010 + 1011
b. 0.1011 + 0.1111
c. 1111 + 0011
d. 1001101
EE 273 - Homework #1
Due: 28/10
1. Which of the following are analog quantities, and which are digital?
a. Width of a piece of lumber
b. Altitude of an aircraft
c. Timer setting on a microwave oven
d.