Build the circuit of figure 12.1 using R=1 koh and L= 10 mH, but leaving off the load components. Replace the
generator with a 50 ohm resistor and determine the effective source impedance at 10 kHz through hand calculations. Record this value in Table 12.1, including both magnitude and phase. Determine the load impedance which should achieve maximum power transfer according to the theorem and record in Table 12.1. Finally, determine values for Rload and Cload to achieve this load impedance and record in Table 12.1, also copying the resistance value to the first Rload entry of Table 12.2.
Please fill out the following table