a. Using the VT of Part 1for each diode sketch the expected output waveform vo on
Fig. 4.4. Choose a vertical and horizontal sensitivity commensurate with the secondary voltage. Consult your oscilloscope to obtain a list of possibilities. Record your choice for each below.
b. Using the oscilloscope with the coupling switch in the DC position obtain the waveform for Vo and record on Fig. 4.5. Use the same sensitivities employed in Part 2(c) and be sure to preset the Vo = 0V line using the GND position of the coupling switch. Label the maximum and minimum values of the waveform using the chosen vertical sensitivity.
Please explain the difference of the waveforms that will be produced in these two situations?
Recently Asked Questions
- A piezoresistive accelerometer has a full scale of 100g with a full scale output of 100 mV. You have an 8-bit analog-to-digital conversion system with a
- How many 1.5V batteries would be needed to illuminate a 5mm LED? Is it possible to use multiple AA or D batteries to light a LED?
- Please refer to the attachment to answer this question. This question was created from analog_techniques_jan2011. Additional comments: "what is this"